Preparation and Characterization of Carbon Nanotube Deposited Carbon Fiber Reinforced Epoxy Matrix Multiscale Composites

Abstract

A B S T R A C TIn this study, desized carbon fibers were coated with carbon nanotubes using two diverse coating techniques, i.e. dip coating and spray up process, while the factors affecting the coating techniques were investigated. The morphological study revealed better nanotube coating on carbon fibers from dip coating technique as compared to spray up process. Later, nanotubecoated fibers from dip coating were impregnated with epoxy to fabricate multiscale carbon fiber reinforced epoxy matrix composites. The nanotubes on fiber surface were expected to improve the interlaminar shear properties of the multiscale composites. According to short beam shear testing, 14% increase in interlaminar shear strength was observed in composite containing nanotubes as compared to reference composite. Microscopic observation under optical and electron microscopes confirmed the void-free impregnation of fibers with epoxy along with the presence of nanotubes on fibers and in matrix in the vicinity of fibers. Finally, the mechanisms involving the enhanced interlaminar properties were identified and discussed.

Carbon nanotubes in carbon/epoxy multiscale textile preform composites: A review

“…MWCNTs (3 wt%) Aqueous suspension deposition 14% increase in ILSS Awan et al [160] 2D biaxial carbon fiber fabric (plain)…”

Carbonaceous Materials Coated Carbon Fibre Reinforced Polymer Matrix Composites

“…The material of the substrate usually has to be considered by the chemical resistance to the solution of coating and the heat resistance to endure the consequent curing or post-treatment. Awan et al [ 127 ] prepared the CNT coated CF reinforced epoxy matrix multiscale composites. By using dip coating and spray-up processes, the deposition of multiwalled CNTs on micrometer-sized CFs was obtained.…”

Mechanically Improved and Multifunctional CFRP Enabled by Resins with High Concentrations Epoxy-Functionalized Fluorographene Fillers

“…Carbon-based materials use in polymer sizing have drawn a lot of attention to this approach because of their superior mechanical properties, chemical structure like that of CFs, and most importantly due to their high aspect ratio. Methods including electrophoretic deposition [4,5], spray [6,7], and dip coating [8][9][10][11][12] have been employed to deposit graphene and carbon nanotubes onto CFs surfaces. CFRPs made with these coated CFs show ~20-70% improvement on interlaminar shear strength.…”