Preparation of MoS2 Nanospheres using a Hydrothermal Method and Their Application as Ammonia Gas Sensors Based on Delay Line Surface Acoustic Wave Devices

Abstract

An ammonia sensor based on a delay-line surface acoustic wave (SAW) device is developed in this study by coating the delay line area of the device with a nano-structured molybdenum disulfide (MoS2) sensitive material. A SAW device of 122 MHz was designed and fabricated with a pair of interdigital transducers (IDTs) defined on a 128° y-cut LiNbO3 substrate using photolithography technologies, and the aluminum IDT electrodes were deposited by a DC magnetron sputtering system. By adjusting the pH values of precursor solutions, molybdenum disulfide (MoS2) nanospheres were prepared with various structures using a hydrothermal method. Finally, an NH3 gas sensor with high sensitivity of 4878 Hz/ppm, operating at room temperature, was successfully obtained. The excellent sensitivity performance may be due to the efficient adsorption of NH3 gas molecules on the surfaces of the nanoflower-like MoS2, which has a larger specific surface area and provides more active sites, and results in a larger change in the resonant frequency of the device due to the mass loading effect.

Ni/WS2/WC Composite Nanosheets as an Efficient Catalyst for Photoelectrochemical Hydrogen Peroxide Sensing and Hydrogen Evolution

“…To overcome these shortcomings, nano-sized 2D material has been used as a support to fabricate various nanocomposites with large interfacial contact, and thus provide abundant active sites and good electrical conductivity for chemical reactions [ 26 , 27 , 28 , 29 , 30 ]. In addition, the nanocomposites are composed of two or more nanoscale materials.…”