Printed Resistive Sensor Array Combined with a Flexible Substrate for Ethanol and Methane Detection

Abstract

In this research, we combined printed electrodes and a flexible substrate to develop a low-cost, resistive, gas sensor with small energy consumption. The ability to measure a gas is derived from an analysis of the resistance change resulting from gas molecules adsorbed by a polymer. With the sensor array coated with various polymers, we can identify the gas type and its concentration. Eight combinations of electrode with different width and gap were designed. The electrodes were printed on PET substrates with silver ink. Sensing material developed with mixture of Polyvinylpyrrolidone (PNVP), Carbon Black (CB) and solvent ethylene glycol (EG) was then coated on the sensors and tested with ethanol and methane. The layout design of the width and gap with the greatest sensitivity towards gases is 20 μm/20 μm. The limit of detection (LOD) is 40 ppm for ethanol and 36 ppm for methane; the resistance changes of the two gases are apparently opposite. Besides this, sensors coated with other sensing materials developed with combination of CB,polymers, poly(4-vinylpyridine)(P4VP) and polystyrene (PS) with solvent, EG and Tetrahydofuran (THF) respectively were measured with gases at varied concentration to derive the sensitivity of each. According to these experiments, a flexible gas sensor shows a great potential to achieve the purpose of establishing a wearable sensing platform.

Correlation between Microstructure and Chemical Composition of Zinc Oxide Gas Sensor Layers and Their Gas-Sensitive Properties in Chlorine Atmosphere

“…The human chlorine detection threshold is less than 1 ppm. When the concentratio it is great, the sense of smell is impaired and it gradually causes more and more heal nsequences, ranging from irritation to the respiratory system to suffocation in extreme cas 3,54].…”

“…Resistive gas sensors due to their simple construction, low cost and large range of detectable gases as carbon monoxide [1], nitrogen oxides [2] or methane [3], are widely used in commercial gas detection systems. Gas-sensitive materials used in such sensors are made of metal oxides with semiconductor properties.…”

Gas sensing based on organic composite materials: Review of sensor types, progresses and challenges

“…Wei et al [55] studied the influence of the geometric structure of the IDEs (line width / gap width, see numerical values in Table 2) on the response of ethanol and methane gas sensors.…”

Gas Sensor Based on ZnO Nanostructured Film for the Detection of Ethanol Vapor

“…The sensor was found to be sensitive to ethanol vapor, and the gas sensitivity mechanism was detailed. Wei et al synthesized an ethanol sensing material based on the mixture of Polyvinylpyrrolidone (PNVP), Carbon Black (CB) and solvent ethylene glycol (EG) [21]. The low detection limit of the sensor was 40 ppm corresponding to a 1.6% response.…”