Processing Fiber‐Reinforced Polymers: Specific Wear Phenomena Caused by Filler Materials

Abstract

Fiber‐reinforced polymers allow for the implementation of plastic materials in structural components. However, increasing incorporation of fibers up to 50 wt% causes accelerated component wear in injection molding machines. In particular, the barrel and screw in the compression zone suffer from increased wear. The abrasive fibers of the compacted polymer pellets in the solid bed protrude from the surfaces of the resin having an abrasive, brush‐like behavior. A modified pin‐on‐disk testing system with specially designed polymer pins was used to emulate the described tribological system in laboratory scale. Through varying contact pressure, temperature, and surface modifications of the counterparts (blank or coated powder‐metallurgical steel), abrasive wear as observed in industrial‐sized extruder screws could be successfully simulated on a laboratory‐scale testing system. Detailed investigations of the pins and disks highlighted that the glass fibers plow and cut the surface leading to abrasion as observed in the real field application. Temperature has been proven to be the most decisive driving force. Surface modifications such as protective physical vapor‐deposited CrN coatings are effective against abrasive wear, clearly outperforming untreated steels. The presented pin‐on‐disk‐test setup will improve screening of materials for extruders, thus enhancing the durability of injection molding machines. POLYM. ENG. SCI., 60:78–85, 2020. © 2019 Society of Plastics Engineers

Comparison of the nanoindentation results of two generation of powder metalurgy produced materials for plastic industry

“…A. Blutmager Et Al. [5] designed apparatus for testing of materials used for plastification units and its components.…”

Comprehensive review of tribometer dynamics-Cycle-based data analysis and visualization

“…For this setup, a few standard test methods provided by international standard organizations, such as the American Society for Testing and Materials (ASTM) or the International Organization for Standardization (ISO), can be used, e.g., ASTM-99 [4] or ISO 7148-1 [5] and ISO 7148-2 [6]. It is a well-established method for characterizing lubricant properties [7][8][9], material pairings in dry contact [10,11], or specific geometries [12,13]. Typically, the disc is operated at a constant rotational speed.…”

Abrasive/Erosive Wear on MMCs in Plastic Molds as a Function of Volumetric Flow Rates and Glass Fiber Distribution

“…A profitable and stable injection molding process requires increasing performance and high resistance against corrosion, wear, and fatigue of tools . In order to select materials with these properties efficiently, tribological testing is required.…”