Real-Time Hardware-in-the-Loop Simulator Based Triggering Pulse Generator for Single Phase Inverter

Biswas, Shuvra Prokash; Hosain, Md. Kamal; Rahman, Md. Waliur; Mondol, Md. Halim; Mazumder, Parag

doi:10.1109/icaeee.2018.8643009

Cited by 4 publications

(2 citation statements)

References 9 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The Simulink Support Package for Arduino Hardware offers a simple method for developing code that utilize Simulink blocks that support Arduino and can be included in your Simulink model. [11][12][13] The blocks are used to configure the associated analog pin and PWM pins, as well as to read and write data to them. The PV voltage and current are measured using the analog pins on the Arduino A0 and A1 and the measured data are passed on to MATLAB to obtain the precise duty ratio for the applied irradiance.…”

Section: Software Implementationmentioning

confidence: 99%

Design and Analysis of Single Switch Double Enhanced Boost Converter for PV Applications

Ramprasath,

Krishnakumar

2023

ITM Web Conf.

View full text Add to dashboard Cite

This paper presents a systematic and analytical investigation of the non-isolated Single Switch Double Enhanced Boost Converter topology. In simple words combination of a DEC (Double Enhanced Circuit) With an ordinary boost converter. The proposed converter implements the output voltage increasing in geometric progression but with a simpler structure. There is one switch S, n inductors, (n + 2) capacitors, and (2n + 1) diodes in each circuit of the additional series. They also effectively enhance the voltage transfer gain in the power law. Steady-state equations were derived to examine the behaviour of the proposed converter. The proposed converter was designed for 100 W and simulated in MATLAB/Simulink, the simulation results demonstrate its effectiveness in terms of improved efficiency, reduced voltage stress, and enhanced power delivery to the load.

show abstract

Section: Software Implementationmentioning

confidence: 99%

Design and Analysis of Single Switch Double Enhanced Boost Converter for PV Applications

Ramprasath,

Krishnakumar

2023

ITM Web Conf.

View full text Add to dashboard Cite

show abstract

“…In order to realize the HIL hardware-in-the-loop test of the inverter power supply controller and the inverter power supply circuit model, it is necessary to configure the interfaces of the models respectively [7] . The inverter power supply circuit model simulates the controlled object of the circuit, so it should be equipped with corresponding output voltage signal and current signal.…”

Section: Hil Model Interface Configurationmentioning

confidence: 99%

Hardware-in-the-loop simulation of inverter power supply controller based on StarSim and DSP

Zhou

Zhao²,

Chen

2022

J. Phys.: Conf. Ser.

View full text Add to dashboard Cite

Aiming at the contradiction between the requirements for rapid development and verification of inverter power supply controller products and the actual construction of real inverter power supply circuit topology, this paper proposes to build a semi-physical simulation platform based on StarSim and DSP. This paper takes the single-phase full-bridge inverter power supply as an example, use Shanghai ModelingTech company’s StarSim real-time simulator as the hardware platform, establish the circuit model in Matlab/Simulink and select NI PXIe-7846R board to run circuit extensions, and use TMS320F28335 as controller of the phase inverter power supply, based on StarSim HIL host computer program to load the model, configure the IO, and test and verify. The experimental results show that the semi-physical test platform has high accuracy and feasibility, shortens the development cycle of the controller, and greatly reduces the development cost of the controller.

show abstract

Study on Power Converters Control in Hardware System Using Low Cost Microcontroller

Zulkifli

Tan

Yusof

2020

2020 IEEE Student Conference on Research and Development (SCOReD)

View full text Add to dashboard Cite

Real-Time Hardware-in-the-Loop Simulator Based Triggering Pulse Generator for Single Phase Inverter

Cited by 4 publications

References 9 publications

Design and Analysis of Single Switch Double Enhanced Boost Converter for PV Applications

Design and Analysis of Single Switch Double Enhanced Boost Converter for PV Applications

Hardware-in-the-loop simulation of inverter power supply controller based on StarSim and DSP

Study on Power Converters Control in Hardware System Using Low Cost Microcontroller

Contact Info

Product

Resources

About