Recent IBA setup improvements in Chile

Miranda, P.; Chesta, M. A.; Cancino, Simón; Morales, J. R.; Dinator, M. I.; Wächter, J. De; Tenreiro, Claudio

doi:10.1016/j.nimb.2006.02.006

Cited by 15 publications

(8 citation statements)

References 6 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The high current ion implanter installed at LATR-IST, represented in Figure 1, is the model 1090 of Danfysik [6] [7].…”

Section: System Descriptionmentioning

confidence: 99%

Improvement of the Mass Spectrometry Process on an Ion Implantation

Lopes¹,

Rocha²,

Redondo³

et al. 2016

OJOp

View full text Add to dashboard Cite

Mass spectrometry is an essential part of ion implantation. Therefore, in order to guarantee beam purity avoiding contamination of the implanted samples, a system was developed for the high current implanter at the Laboratory of Accelerators and Radiation Technologies (LATR) at the Instituto Superior Técnico. The system presented and discussed in this paper was developed using a LabVIEW code and uses a PC to control and display the mass spectrum. It also permits to save all data acquired for posterior analysis. In order to show some capabilities of this system, some experimental results are presented.

show abstract

“…The high current ion implanter installed at LATR-IST, represented in Figure 1, is the model 1090 of Danfysik [6] [7].…”

Section: System Descriptionmentioning

confidence: 99%

Improvement of the Mass Spectrometry Process on an Ion Implantation

Lopes¹,

Rocha²,

Redondo³

et al. 2016

OJOp

View full text Add to dashboard Cite

show abstract

“…Targets were characterized by PIXE and RBS [11] techniques. The experimental setup can be found elsewhere [13]. For RBS analysis the theoretical fitted spectra was calculated using the SIMNRA code [12], The RBS method allowed determination of zinc targets thickness which were 2.5±0.2 µm, approximately.…”

Section: Target Preparationmentioning

confidence: 99%

Production yields of^NatZn(p,x)⁶⁷Ga reaction in the energy range of 1.6 to 2.5 MeV

Wächter

Miranda

Cancino

et al. 2008

J. Phys.: Conf. Ser.

View full text Add to dashboard Cite

“…The method was tested at the Van de Graff accelerator of the University of Chile [3] using proton beams of 2.2 MeV with intensities of 1.5 nA. Four Mylar films having 3.5 lm thickness coated with about 45 lg/cm 2 of cobalt were obtained from Micromatter Co. Cobalt was selected because it is an element rarely found in common materials.…”

Section: Test and Application Examplementioning

confidence: 99%