Regenerating the NC code in order to improve the surface quality

Lazarević, Dragan; Nedić, Bogdan; Marušić, Vlatko; Mišić, Milan; Šarkoćević, Živče

doi:10.17559/tv-20161018122324

Cited by 1 publication

(2 citation statements)

References 12 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…As the output characteristics of the process, the cutting force and the roughness of the treated surface were selected, as the most commonly used machinability [1,6]. Measurement of the cutting force was carried out using the measuring system shown in Fig.…”

Section: Experimental Partmentioning

confidence: 99%

“…Research in this paper was carried out on aluminum alloy 6061. Consequently, it can be concluded that this area is still interesting for research, that is, the optimization of parameters on new alloys has not been sufficiently investigated [6,7]. Another work, which certainly deserves readers' attention, is the work [8] where authors adapt parameter optimization in the milling process of AISI 1045 materials.…”

Section: Introductionmentioning

confidence: 99%

See 1 more Smart Citation

Optimization of Machining Parameters Using the Taguchi and ANOVA Analysis in the Face Milling of Aluminum Alloys AL7075

et al. 2020

View full text Add to dashboard Cite

This paper examines the influence of the cutting parameters on the cutting forces and the surface roughness at the face milling process when machining aluminum alloy 7075 is obtained by the new SSM casting process. The parameters of the milling process are the cutting speed, the feed per tooth and the depth of cut. The experiments were performed according to the Taguchi method according to the L9 plan and the factors varied at three levels. For analysis of the effects of these parameters S/N ratio is used. In addition, ANOVA analysis was performed, i.e. analysis of the variance of the selected parameters. The analysis of the results shows that the optimal combination for the cutting force is the choice of a minimum level for all tested parameters. In contrast, for average arithmetic roughness, the optimal processing regime is achieved with minimum values for cutting speed and feed per tooth, whilst it is preferable to choose the cutting depth at the median level for the observed range. In addition, the study shows that the Taguchi method is suitable for solving the problem, where the research was carried out with a minimum number of tests compared to a full factorial experimental plan.

show abstract

Section: Experimental Partmentioning

confidence: 99%