Research Concerning the Impact of Geometrical Characteristics of Natural Quarry Aggregates Used in the Composition of Asphalt Concrete

Abstract

The paper presents studies and laboratory tests concerning the influence of the way the natural quarry aggregates are processed upon the composition of an asphaltic concrete with a maximum grain size of 16 mm (BA 16). The research included the realization of grading curves on certain aggregates, curves lately compared to the maximum density line. This approach aims at classifying certain aspects concerning some of the physical-mechanical characteristics of the asphalt concretes determined through static and dynamic laboratory tests. The research resulted from the fact that in Romania, the elementary gradings on granular fractions from the same source, entering the composition of a certain asphalt mix, differ most of the times depending on the manipulation and the processing manner, respectively. This finding is based on the experience of the laboratory testing, where different values concerning the volume weight, apparent volume weight, voids and rigidity module were obtained on the same asphalt mix dosage prepared according to the prescription in two separate samples.Thus, in order to emphasize the impact of the processing manner (crushing) of the natural aggregates, the authors determined the percentage distribution on intermediate granular fractions of the gradings entering the composition of an asphalt concrete. Since the Romanian Standard for asphalt mixtures stipulates a large grading envelope between the standard sizes corresponding to each grading, the authors considered that there is no uniform distribution ratio depending on the size of the grains entering its composition. The study started from different research methods found in the specialized literature dealing with the calibration of the optimal grading curve. The results of the laboratory tests performed on the asphalt mixture confirm the importance of the particle size analysis in obtaining high quality physical-mechanical characteristics.

Aspects concerning the physical-mechanical characteristics of low-noise asphalt mixture

“…The components for the asphalt mixture design were selected according to previously conducted research [22,23].…”

“…Adelin Stirb, Pual Marc, Andrei Forton Aspects concerning the physical-mechanical characteristics of low-noise asphalt mixture needed to be used as natural stone for roads, railways and constructions. A 0-16 mm aggregate skeleton was used for the study [22].…”