Research of Rational Variants of Modernization of Armored Troop-Carrier BTR-70

Abstract

Currently, the National Guard of Ukraine and other power structures of the state are actively working on the acquisition of subdivisions with modern weapons, including armored vehicles. For objective reasons, such work cannot be done in a short time, therefore, the BTR-70 armored troop-carrier, developed and adopted in the seventies of the last century, is still in operation in significant numbers. An analysis of the design of the armored troop-carrier indicates that its power plant has structural features that do not fully meet modern approaches to the design of such weapons and, moreover, the vehicles have practically exhausted their assigned resource. However, the experience of operating the BTR-70, including in the combat zone, testifies that the potential capabilities and maintainability inherent in its design make it possible to use the armored troop-carrier even after the end of its intended resource, although the aforementioned complicates and increases the cost of operation. One of the ways to solve this problem is the modernization of the power plant of the armored troop-carrier, in particular, the replacement of gasoline engines with modern diesel engines and the improvement of the transmission design. In the course of the study, traction and speed properties of the armored vehicle in the standard configuration and when equipped with two D245.30E2 engines and Deutz engines are calculated and estimated. As a change in the design of the transmission, the option of replacing the standard gearbox with a gearbox with an overdrive is considered. It was found that equipping an armored personnel carrier with modern diesel engines in both cases leads to a significant increase in traction properties and an improvement in the fuel efficiency of the vehicle. However, due to the fact that the crankshaft speed of diesel engines is approximately 25-30 % lower than the corresponding frequency of gasoline engines, the maximum speed of an armored personnel carrier with diesel engines is limited by the design of the transmission and is about 70 km / h. This does not meet modern requirements for machines of this type, therefore, as an option; it is proposed to install a step-up reducer (divider) at the inlet of the gearbox. In this case, it is possible to reduce the gear ratio of the transmission in higher gears and, accordingly, increase the maximum speed of the armored troop-carrier on paved roads.