Research on Chrome Plating Quality of the Internal Surfaces in the Hydraulic Drives with Hydrostatic Guideways

Abstract

The article presents a study of the characteristics of experimental samples with a chrome coating: the straightness and ovality of the inner surface of the cylinder, as well as the hardness and thickness of the chrome coating. The chrome coating is obtained on a previously developed installation for applying chrome coating on the inner surfaces of hydraulic cylinders of hydraulic drives with hydrostatic guides. The measurement of the geometric characteristics of the internal surface of the samples was carried out, the values ​​of deviations from roundness and deviations from straightness were obtained. A study of the chrome coating was carried out, for this we cut out sectors from the samples, carried out their sample preparation, measured the hardness and took pictures under a microscope, measured the hardness and thickness of the chrome coating. The obtained measurement results: deviation from roundness, deviation from straightness, coating hardness, coating thickness - correspond to the specified technical requirements, the proposed construction of the installation for applying chrome coating to the inner surfaces and the electrolyte composition, selected earlier, are applicable for chrome plating of the inner surfaces.

The Use Hot Stamping to Restore the Efficiency Tie Rod Ball Pins Trucks

“…In the event lack lubrication during piercing, the edges the cavity formed in the restored element the part may have a surface with micro cavities [17]. These micro cavities are stress concentrators during further operation the part [18]. To eliminate micro cavities, the restoration process must contain cutting operations (drilling, countersinking, etc.…”

Punches and Matrices Recovery for Hot Punching by Electric Arc Hardfacing

“…Interlayer cleaning seams from slag and splashes is carried out to bare metal, while the crater is welded with a short arc with minimal penetration. The position the welding spot should be lower semi-vertical [15].…”