Research on the Application of Self-optimizing Control Algorithm in Tuned Filters

Deng, Yi; He, X. T.; Zhao, Guojin; Zhu, Kuihu; Zhang, Xuewen

doi:10.1007/978-981-19-3927-3_19

Cited by 1 publication

(1 citation statement)

References 7 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…This technology consists of digital imaging, image processing, auxiliary facilities, etc. The actual size of the steel core pressed into the steel anchor is obtained by transforming the position and size measurement software of the ground wire, and accurate positioning of the automatic crimping size of the ground wire can be achieved without damaging the ground wire [2]. The specific measurement principle of the crimping size of the grounding wire is shown in Figure 3.2.…”

Section: Measurement Of Conductor Crimping Size Based On X-ray Digita...mentioning

confidence: 99%

Application of Control Algorithm in the Design of Automatic Crimping Device for Connecting Pipe and Ground Wire

Sheng,

Xing,

Cai

et al. 2024

SCPE

View full text Add to dashboard Cite

Due to the low effectiveness and poor quality of manual crimping of grounding wires, the author proposes the design of an automatic crimping device for connecting tube grounding wires based on intelligent fully automatic technology. The device consists of a microcontroller, an upper computer control interface, an electric push rod, an infrared sensor, a pressure transmitter, and other devices. The staff used the upper computer monitoring interface to set the relevant parameters for grounding wire crimping, and used X-ray digital imaging technology to measure the crimping size of the grounding wire. The size met the set parameter conditions. Through the PID control algorithm in the microcontroller, the stepper motor was controlled to push the clamp to move, completing the automatic crimping of the grounding wire. The X-ray detection method was introduced to detect the quality of the grounding wire after the crimping was completed. The experimental results show that the average deviation between the measured crimping size of the grounding wire and the actual measurement size by the automatic crimping device is only 0.06 mm, indicating that its measurement results are accurate; The success rate of crimping exceeds 95%. The above experimental results verify that the designed crimping device has high stability and reliability, and good quality detection effect.

show abstract

Section: Measurement Of Conductor Crimping Size Based On X-ray Digita...mentioning

confidence: 99%

Application of Control Algorithm in the Design of Automatic Crimping Device for Connecting Pipe and Ground Wire

Sheng,

Xing,

Cai

et al. 2024

SCPE

View full text Add to dashboard Cite

show abstract

Research on the Application of Self-optimizing Control Algorithm in Tuned Filters

Cited by 1 publication

References 7 publications

Application of Control Algorithm in the Design of Automatic Crimping Device for Connecting Pipe and Ground Wire

Application of Control Algorithm in the Design of Automatic Crimping Device for Connecting Pipe and Ground Wire

Contact Info

Product

Resources

About