Research on the Surface Potential of Spinal Cord based on the Finite Element Analysis

Hong, Bo; Shen, Xipeng; Liu, Yong; Wu, Fang

doi:10.1016/j.aasri.2014.08.009

Cited by 1 publication

(1 citation statement)

References 6 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…[6] Under the social background of "double reduction", low-carbon and environmental protection, the design of elevator weights carrying robot should be more accurate, safe, economical and in line with the current social needs [7]. Based on these problems, by consulting the literature, the existing finite element analysis method is varied, mainly through the use of ANSYS, ABAQUS, MSC and other software to complete the finite element analysis task and get accurate analysis results, so the finite element analysis of key parts is feasible [8,9]. Therefore, this paper will use threedimensional modeling software simulation module to carry out finite element analysis on the bearing capacity, bending fatigue and other characteristics of the key parts of the elevator weights carrying robot.…”

Section: Introductionmentioning

confidence: 99%

Finite element analysis of key parts of elevator weights carrying robot

Han

Song

et al. 2023

Third International Conference on Mechanical, Electronics, and Electrical and Automation Control (METMS 2023)

View full text Add to dashboard Cite

The performance of the key parts of the elevator weights carrying robot determines the security of the entire device. The traditional theoretical calculation method may have problems such as low calculation accuracy, long time, large data error and inaccurate calculation results., the paper proposes to use the finite element analysis method to analyze the key parts. The finite element analysis of the bearing capacity and bending fatigue of the key parts of the elevator weights carrying robot is carried out by using the three-dimension modeling software simulation module. The stress-strain analysis results are obtained by means of three-dimensional modeling, finite element model establishment, material performance analysis and stress analysis of key parts. The results did not exceed the maximum allowable stress of the material, and the maximum displacement was within the allowable range, which met the analysis requirements and realized the reliability and safety detection of the key parts of the Carrying Robot. The test results meet the required requirements.

show abstract

Section: Introductionmentioning

confidence: 99%