Review of the Application of Intelligent Optimization Algorithm for Design of Novel Electric Machines

Shang, Yanzhe; Liang, Deliang; Jia, Shaofeng; Luo, Yugong; Wang, Hao

doi:10.1007/978-981-33-6609-1_36

Cited by 1 publication

(1 citation statement)

References 11 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Set the Wheatstone bridge on the diffusion silicon chip inside the pressure transmitter. When the measured liquid is pressurized, the bridge wall resistance value produces a piezoresistive effect, generating a differential voltage signal [17]. Use an internal dedicated amplifier to convert the signal corresponding to the range into an analog voltage signal , and use the I/O pins of the microcontroller to input the analog voltage signal into the microcontroller.…”

Section: High Voltage Transmission Linementioning

confidence: 99%

Application of Control Algorithm in the Design of Automatic Crimping Device for Connecting Pipe and Ground Wire

Sheng,

Xing,

Cai

et al. 2024

SCPE

View full text Add to dashboard Cite

Due to the low effectiveness and poor quality of manual crimping of grounding wires, the author proposes the design of an automatic crimping device for connecting tube grounding wires based on intelligent fully automatic technology. The device consists of a microcontroller, an upper computer control interface, an electric push rod, an infrared sensor, a pressure transmitter, and other devices. The staff used the upper computer monitoring interface to set the relevant parameters for grounding wire crimping, and used X-ray digital imaging technology to measure the crimping size of the grounding wire. The size met the set parameter conditions. Through the PID control algorithm in the microcontroller, the stepper motor was controlled to push the clamp to move, completing the automatic crimping of the grounding wire. The X-ray detection method was introduced to detect the quality of the grounding wire after the crimping was completed. The experimental results show that the average deviation between the measured crimping size of the grounding wire and the actual measurement size by the automatic crimping device is only 0.06 mm, indicating that its measurement results are accurate; The success rate of crimping exceeds 95%. The above experimental results verify that the designed crimping device has high stability and reliability, and good quality detection effect.

show abstract

Section: High Voltage Transmission Linementioning

confidence: 99%