Review on role of intermetallic and ceramic particles in recrystallization driving force and microstructure of wrought Al alloys

Liu, Tian-Shu; Dong, Bai-Xin; Yang, Hong-Yu; Qiu, Feng; Shu, Shi-Li; Jiang, Qi-Chuan

doi:10.1016/j.jmrt.2023.10.098

Cited by 19 publications

(2 citation statements)

References 126 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Regarding the reinforcement, it seems that DRV and DRX are more pronounced for SiC p /A357 compared to A357. In general, it is assumed that the reinforcing particles enhance the multiplication and interaction of dislocations during hot deformation and thus promote dynamic recrystallisation [45].…”

Section: Compressive Behavior At 350 • Cmentioning

confidence: 99%

“…The mechanisms identified for the unreinforced material can presumably be applied to the AMCs. However, the extent of DRX is assumed to be significantly more pronounced due to the reinforcement [45], resulting in the observed stronger softening. Beside this, an additional reduction in strength was identified by Liu et al [52].…”

Section: Microstructural Evolution Of Amcs During Compressionmentioning

confidence: 99%

See 1 more Smart Citation

Combined Effect of Particle Reinforcement and T6 Heat Treatment on the Compressive Deformation Behavior of an A357 Aluminum Alloy at Room Temperature and at 350 °C

Hirsch,

Berndt,

Grund

et al. 2024

Crystals

View full text Add to dashboard Cite

Solid state sintering of cast aluminum powders by resistance heating sintering (RHS), also known as spark plasma sintering or field-assisted sintering technique, creates a very fine microstructure in the bulk material. This leads to high performance material properties with an improved strength and ductility compared to conventional production routes of the same alloys. In this study, the mechanical behavior of an RHS-sintered age-hardenable A357 (AlSi7Mg0.6) cast alloy and a SiCp/A357 aluminum matrix composite (AMC) was investigated. Aiming for high strength and good wear behavior in tribological applications, the AMC was reinforced with a high particle content (35 vol.%) of a coarse particle fraction (d50 = 21 µm). Afterwards, separated and combined effects of particle reinforcement and heat treatment were studied under compressive load both at room temperature and at 350 °C. At room temperature compression, the strengthening effect of precipitation hardening was about twice as high as that for the particle reinforcement, despite the high particle content. At elevated temperatures, the compressive deformation behavior was characterized by simultaneously occurring temperature-activated recovery, recrystallisation and precipitation processes. The occurrence and interaction of these processes was significantly affected by the initial material condition. Moreover, a rearrangement of the SiC reinforcement particles was detected after hot deformation. This rearrangement lead to a homogenized dispersion of the reinforcement phase without considerable particle fragmentation, which offers the potential for secondary thermo-mechanical processing of highly reinforced AMCs.

show abstract

Section: Compressive Behavior At 350 • Cmentioning

confidence: 99%

Section: Microstructural Evolution Of Amcs During Compressionmentioning

confidence: 99%