Rice husk bio‐filler reinforced polymer blends of recycled HDPE/PET: Three‐dimensional stability under water immersion and mechanical performance

Abstract

Green composite materials were made from agricultural and plastic wastes which were rice husk (RH), recycled high‐density polyethylene (rHDPE), and recycled polyethylene terephthalate (rPET), by twin‐screw extrusion and hot/cold pressing molding. The dimensional stability, orthotropic swelling, and mechanical performance of the green composites were determined as a function of bio‐filler concentration for neat (uncompatibilized) and compatbilized rHDPE/rPET blend based composites. Water absorption and swelling results showed a linear increase with the RH concentration. The highest swelling occurred in the thickness of the composites, followed by the width and length, respectively. Water absorption and dimensional instability of compatibilized recycled polymer blend (rPB)‐based composites were lower than those of neat rPB‐based composites. As RH concentration increased, the flexural properties increased significantly. The optimum tensile strength and modulus were achieved at 70 wt% RH. It is interesting to note that compatibilization of polymer blend matrix had further increased the strength and elongation properties of composites. POLYM. COMPOS., 39:2695–2704, 2018. © 2016 Society of Plastics Engineers

An Investigation on the Comprehensive Property Assessment and Future Directions of Single Bamboo Fiber Reinforced Polypropylene Composites Fabricated by a Non-Woven Paving and Advanced Molding Process

“…This may be because the fibers act as defects in the composites when the content of SBFs exceeds the limit. At high fiber concentrations, fibers are not sufficiently wetted by the matrix (a smaller amount), and this results in lower interface adhesion between the SBFs and PP, such that ineffective stress is transferred from the matrix to the fiber [36]. This can be confirmed by the fact that a high concentration of agro waste fiber requires higher amounts of a coupling agent to provide better adhesion and mechanical properties [37].…”

Preparation and Characterization of Lemongrass Fiber (Cymbopogon species) for Reinforcing Application in Thermoplastic Composites

“…In other work, it is reported that poor interfacial bonding causes micro-space between the filler and matrix interfaces leading to the development of micro-cracks that in turn enhances fracture propagation (Yang et al 2004). It was also stated that at high filler concentration, there are lots of fiber interactions as a result of the agglomeration of fibers in the composites where it is more sensitive to crack than the matrix-fiber interface (Salasinska and Ryszkowska 2015;Chen et al 2016b). Mengeloglu and Karakus (2012) also reported that increasing fiber loading decreases the impact strength value.…”

Rheological, Morphological and Mechanical Characterization of Recycled Poly (Ethylene Terephthalate) Blends and Composites

“…This increase in mechanical properties of composites in relation to blends occurred due to the presence of linter fibers (fiber are harder than the matrix), providing increased strength and improving rigidity. Chen 35 observed a remarkable increase of the Young's modulus with increasing rice husk (RH) concentration, which can be attributed to the increased stiffness that is caused by the intrinsic properties of RH. In comparison with PET rec , the composite with 2 wt% of EMA and 1 wt% of CL was not observed change of the maximum tensile strength.…”