Role of Residual Monomers in the Manifestation of (Cyto)toxicity by Polystyrene Microplastic Model Particles

Abstract

Polystyrene (PS) is an important model polymer for the investigation of effects of microplastic (MP) and nanoplastic (NP) particles on living systems. Aqueous dispersions of PS MP or NP contain residual monomers of styrene. In consequence, it is not clear if the effects observed in standard (cyto)­toxicity studies are evoked by the polymer (MP/NP) particle or by residual monomers. We addressed that question by comparing standard PS model particle dispersions with in-house synthesized PS particle dispersions. We proposed a rapid purification method of PS particle dispersions by dialysis against mixed solvents and developed a simple method of UV–vis spectrometry to detect residual styrene in the dispersions. We found that standard PS model particle dispersions, which contain residual monomers, exerted a low but significant cytotoxicity on mammalian cells, while the in-house synthesized PS, after rigorous purification to reduce the styrene content, did not. However, the PS particles per se but not the residual styrene in both PS particle dispersions resulted in immobilization of Daphnia. Only by using freshly monomer-depleted particles, will it be possible in the future to assess the (cyto)­toxicities of PS particles, avoiding an otherwise not controllable bias effect of the monomer.

Bio-based electrospun polyamide membrane – sustainable multipurpose filter membranes for microplastic filtration

“…S6†). 69 The polystyrene dispersion was diluted with distilled water to yield five calibration dispersions. The calibration was performed in a range between 1.88 μg mL −1 and 30 μg mL −1 .…”

Surface topography of nanoplastics modulates their internalization and toxicity in liver cells

“…The purity of the synthesized AIE-NPs was characterized using a UV-vis spectrometer (Shimadzu, Japan), as reported previously. 32 The purity was measured to be around 99.95% when the concentration of AIE-NPs was 1000 mg mL −1 . The concentration of residual styrene was about 0.5 mg L −1 in the stock and 5 × 10 −4 μg L −1 in the exposure medium.…”