Scalable Electrodeposition of Liquid Metal from an Acetonitrile‐Based Electrolyte for Highly Integrated Stretchable Electronics

Abstract

The advancement of highly integrated stretchable electronics requires the development of scalable sub‐micrometer conductor patterning. Eutectic gallium indium (EGaIn) is an attractive conductor for stretchable electronics, as its liquid metallic character grants it high electrical conductivity upon deformation. However, its high surface tension makes its patterning with sub‐micrometer resolution challenging. In this work, this limitation is overcome by way of the electrodeposition of EGaIn. A non‐aqueous acetonitrile‐based electrolyte that exhibits high electrochemical stability and chemical orthogonality is used. The electrodeposited material leads to low‐resistance lines that remain stable upon (repeated) stretching to a 100% strain. Because electrodeposition benefits from the resolution of mature nanofabrication methods used to pattern the base metal, the proposed “bottom‐up” approach achieves a record‐high density integration of EGaIn regular lines of 300 nm half‐pitch on an elastomer substrate by plating on a gold seed layer prepatterned by nanoimprinting. Moreover, vertical integration is enabled by filling high‐aspect‐ratio vias. This capability is conceptualized by the fabrication of an omnidirectionally stretchable 3D electronic circuit, and demonstrates a soft‐electronic analog of the stablished damascene process used to fabricate microchip interconnects. Overall, this work proposes a simple route to address the challenge of metallization in highly integrated (3D) stretchable electronics.

Investigation of healing electronic pressure-sensitive soft switch based on liquid metal microfiber

“…The gallium-based LMs at room temperature (RT-GaLMs) is important for the development of smart flexible electronics. In addition, there are many methods to process RT-GaLMs [20,21]. For example, a nonaqueous acetonitrilebased electrolyte possessing high electrochemical stability and chemical orthogonality was used for electrodeposition of EGaIn [21].…”

“…In addition, there are many methods to process RT-GaLMs [20,21]. For example, a nonaqueous acetonitrilebased electrolyte possessing high electrochemical stability and chemical orthogonality was used for electrodeposition of EGaIn [21]. Besides, the LM can also be embedding into a flexible rubber matrix to synthesize interconnected LM fiber networks [22].…”