This article presents a 2017 LiDAR-DEM guided 1-m resolution examination of field-surveyed elevation and soil property variations (5 × 5 m spacings) conducted in 1977 across a hummocky New Brunswick field used for potato production. This examination revealed that the field incurred minor elevation differences were likely due to upslope erosion, as revealed through increasing Sand % and CF % with increasing elevation, and increasing Silt % along low-lying areas. Soil moisture, field capacity, permanent wilting and nitrate nitrogen (NO 3 -N) also increased at downslope locations. Directly as well as indirectly, soil pH, ammonium nitrogen (NH 4 -N), Caesium 137 (Cs 137 ) and Mehlich-3 extracted Ca, Mg, K, Fe, Mn, Cu, and Zn were likewise affected by topographic location. Factor analyzing these variables led to: 1) a Soil Loss Factor that captured 24% of the textural variations; 2) a Soil-Cropping Factor accounting for 16% of the N, P, K, Ca, Mg, Mn variations; 3) a Soil Organic Matter (SOM) Factor relating 9% of the in-field variations for SOM, Fe, Zn, Cu to via organo-metal complexation and low NO 3 -N retention. Many of the topographic variations increased or decreased with the metric DEMprojected depth-to-water index (DTW) index. This index was set to 0 along DEM-derived flow channels with minimum upslope flow-accumulation areas of 0.1, 0.25, 0.5, 1 or 4 ha. Among these, the DTW > 4 ha threshold was useful for reproducing the textural variations, while the DTW > 0.25 ha threshold assisted in capturing trends pertaining to moisture retention and elemental concentrations.