Simulation of the insulation monitoring system of the high-voltage electrical network of a vehicle with a hybrid power plant

Abstract

The paper presents the results of mathematical and simulation modeling, as well as calculated and experimental dependencies, which make it possible to evaluate the operation of the insulation resistance monitoring system of the high-voltage power grid of a hybrid vehicle. The work also provides circuits for measuring insulation resistance, a mathematical model in the MATLAB Sim-ulink environment, and the peculiarities of the operation of the software and hardware simulation complex. The aim of the work is to obtain the most reliable mathematical and physical model of insulation resistance, to determine the architecture of a high voltage battery with the IRM system included in it, to identify the key functions and characteristics of the IRM system, to test the simulation system. The introduction justifies the importance of the IRM system and provides references to standards that govern the requirements for measuring and identifying utility faults. The block diagram of the high voltage battery control system is presented. The composition of its main elements is described. The functions and key characteristics of the IRM system are considered, typical characteristics of insulation monitoring systems are given. A schematic diagram of determining the insulation resistance of conductors and an electric circuit is clearly considered. An equivalent circuit of a differential DC amplifier with a unipolar power supply is presented, which is used to amplify small differential voltages on a shunt when changing large common-mode voltages, which is part of the measuring circuit. Mathematical and simulation modeling was carried out to evaluate the method for calculating the insulation resistance according to the well-known scheme, which is used when measuring using the three-voltmeter method. There was considered the mode of checking the the insulation control system, when several test procedures performed containing simulation of the fault and operating condition of the insulation by connecting and measuring the test resistance. The results of physical simulation of the IRM system and measurement of insulation resistance, voltage between each of the high voltage supply wires and the high voltage battery case, voltage between the wires, battery voltage were obtained. The actual insulation resistance was calculated. The conclusions explain the effectiveness of physical and simulation modeling, obtaining a reliable mathematical model and low error in modeling the insulation characteristics.

Development of an Electric All-Wheel-Drive Simulation Model Used to Test Torque Distribution Algorithms

“…The standard deviation calculated by the formula [22] is used as an accuracy criterion for the results:…”