Simulation Time and Energy Test for Topology Construction Protocol in Wireless Sensor Networks

Gupta, Satyam; Gupta, Gunjan

doi:10.11591/ijeei.v3i2.139

Cited by 6 publications

(5 citation statements)

References 3 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Specifically, GS − DOF controller parameter dependent matrices are a convex collection for the parameter value at that moment, the DOF controller matrices computed at the vertices of the system for the imposed parameters and their alteration rates domains. Consequently, stack of matrices are computed for system performance in different application fields, as [9], transmission lines [10,11], wireless sensor networks [12,13], high-voltage systems [14]. For instance, utilizing Lemmas 3 and 2, system (36); and considering fully GS − DOF controller (6), where the sensor senescence is set to 0.9, the robustly synthesized DOF controller matrices are performance can be realized under the H ∞ -performance upper bound.…”

Section: Resultsmentioning

confidence: 99%

“…A faulty sensor (or sensors) may cause system performance degradation, system shut down, and/or fatal accident. The recent literature trend towards the effect of sensors malfunctions to the system performance in different applications, like, wind power generation [9], transmission lines [10,11], wireless sensor networks [12,13], and high-voltage systems [14]. The scope of fault tolerant control is not recent in literature.…”

Section: Introductionmentioning

confidence: 99%

See 1 more Smart Citation

LPV Control Synthesis for Sensor Senescence in Feedback Control System

Madhag

2021

IJEEI

View full text Add to dashboard Cite

The senescence of system sensor(s) probably causing degenerate system behavior or system breakdown. Motivated by that, this work considers the synthesis of a gain scheduling control for linear parameter varying (LPV) system via linear matrix inequalities (LMIs) techniques such that sensors senescence information incorporated in the design of the controller. That is, the degradation of sensor effectiveness due to senescence is modeled by the variation of sensor measurements' noise co-variance. The sensors' senescence information is incorporated as a part of the scheduling parameters for the LPV controller. The synthesis control matrices via linear matrix inequalities have been re-structured and re-formalized in a way that they incorporate the sensors senescence information to synthesize a gain scheduling dynamic output feedback (GS − DOF) control. That is, the existing GS − DOF control design LMIs have been modified to include the noise co-variance matrix. The significant achievement is the control design conditions description of GS − DOF control in a way that ensures the desired integrated H2&H∞ performances in the presence of sensors senescence, where sensors' senescence information is incorporated as a part of the scheduling parameters for the LPV controller. In addition, two sets of controllers have been synthesized and studied. The simulation expresses the benefits of the proposed controllers, and closed loop system H∞ and H2 performances are also studied. The synthesized controller ensures the performance associate with a closed loop, the closed loop system stability, and the scheme of control is simple enough for real time implementations.

show abstract

Section: Resultsmentioning

confidence: 99%

Section: Introductionmentioning

confidence: 99%

LPV Control Synthesis for Sensor Senescence in Feedback Control System

Madhag

2021

IJEEI

View full text Add to dashboard Cite

show abstract

“…The RF antenna is designed by combining the onboard antenna and external drive antenna to improve the coverage area. CC2530 is a special wireless radio frequency chip made by TI, it can run ZigBee network protocol stack to make ZigBee networking join up [10]. Laser ranging sensor OD2-P250W150A0 is made by SICK has high measurement accuracy, high reliability, quick response and various peripheral interfaces.…”

Section: Sensor Node Designmentioning

confidence: 99%

Development of Dynamic Monitoring System of Cement Kiln’s Axis based on WSN

Guo

2016

TELKOMNIKA

View full text Add to dashboard Cite

Aiming at the measurement of cement rotary kiln's axis, the paper presents the design method of a wireless dynamic measurement system for rotary kiln's axis. A wireless sensor network monitoring system that can collect multiple parameters was designed, which integrates the detection functions for kiln shell axis deviation, kiln tire axis deviation and drive gear synchronizing signal, and has the advantages of wireless transmission, low power consumption, and easy to install. ZigBee tree network was developed, which is beneficial to expand the capacity of wireless network, improve the efficiency of data transmission, reduce the cost, and shorten the development cycle. The sever measurement software was designed, which has the functions of data wireless acquisition and analysis for rotary kiln axis. The related prototypes of the monitoring device were developed, which verified the effectiveness of the system on the cement rotary kiln.

show abstract

“…The sensor nodes are battery operated so energy is very important criterion that has to be taken care. WSNs have innumerable applications, but whatever might be the application, limited battery power is a major constraint that has to be considered [3]. There are several challenges in WSN which should be addressed.…”

Section: Introductionmentioning

confidence: 99%

A Comprehensive Study and Analysis of LEACH and HEED Routing Protocols for Wireless Sensor Networks – With Suggestion for Improvements

Anitha¹,

Vijayakumari²,

Thangavelu³

2018

IJEECS

View full text Add to dashboard Cite

<p>The main interesting aspect of the digital era is the widely spread ease of communication from one end of the world to the other end of the world. There is a revolution in communication, digitalization, globalization, video calling, wireless data transfer and this is possible due to networking. Initially computer networks is the data sharing where data such as documents, file, reports, presentation files, videos, images etc can be shared within a local network or remotely connected networks. Traditional data networking is to empower end-to-end information transfer. The data in such networks are carried across point-to-point links and the intermediate nodes just forward the packets, where the payload of the packets is not modified. Traditional LANs need wires, which may be difficult to set up in some situations.</p><p>It is very much understandable and clearly visible that wired communication is being completely overtaken by wireless technologies in the recent past. Wireless LANs, by its very nature, empowers with increased mobility and flexibility. Wi-Fi devices get connected to the internet through WLAN and access points. 2.4 GHz and 5 GHz ISM bands are used by Wi-Fi. Also, it is to be understood that, a wireless adhoc network is distributed in its nature. It is also to be noted that, the adhoc nature makes these network to rely on any of the pre-existing infrastructure. The data forwarding shall happen from the nodes very much dynamically based on the connectivity and the routing algorithm used. </p>

show abstract

Simulation Time and Energy Test for Topology Construction Protocol in Wireless Sensor Networks

Cited by 6 publications

References 3 publications

LPV Control Synthesis for Sensor Senescence in Feedback Control System

LPV Control Synthesis for Sensor Senescence in Feedback Control System

Development of Dynamic Monitoring System of Cement Kiln’s Axis based on WSN

A Comprehensive Study and Analysis of LEACH and HEED Routing Protocols for Wireless Sensor Networks – With Suggestion for Improvements

Contact Info

Product

Resources

About