Simultaneous transmission of clock and data signals in photonic-assisted WDM passive optical networks

Abstract

This work reports on the use of a gain-switched vertical cavity surface-emitting laser (VCSEL) optical frequency comb (OFC) to generate multiple optical carriers for applications in future wavelength-division multiplexing (WDM) passive optical network (PON) systems. The VCSEL-based OFC system was tested for its ability to simultaneously transmit error-free data signals up to 30 Gbps, and a 50 MHz clock signal proposed to be used for latency monitoring of the network. The system was demonstrated over a fiber distance beyond 20 km. Four optical carrier signals were filtered from the generated OFC. Three of the four optical carriers were combined and amplitude-modulated with 5 and 10 Gbps on–off keying (OOK) data signals. The fourth optical carrier was amplitude-modulated with a 50 MHz clock signal. These four modulated optical carriers were multiplexed and transmitted over 21 km of standard single-mode fiber. When the three data-carrying optical carriers were modulated with 5 Gbps OOK data and multiplexed with the clock-carrying carrier, a negligible transmission penalty was achieved after fiber transmission. When these three data-carrying optical carriers were modulated with 10 Gbps OOK data and multiplexed with a clock-carrying carrier, a maximum transmission penalty of 4.8 dB was achieved after fiber transmission. The system was investigated at a minim bit error rate (BER) of 10 − 9 . A receiver sensitivity of less than − 11 d B m was achieved at both bit rates. The clock signal suffered little effect when transmitted with the three optical carriers at both 5 and 10 Gbps data rate. A power penalty of 15.37 dB, mainly due to fiber attenuation, was experienced in the clock after fiber transmission. Due to the unavailability of the numerical system to quantify the clock performance in terms of phase noise, the phase-noise results could not be provided. Nevertheless, the provided qualitative results were able to show that the transmitted clock integrity was able to be retained after being multiplexed with transmission on the 21 km fiber channel. For the first time, to the best of our knowledge, we have simultaneously reported on data and clock transmission results using a low-power, VCSEL-based OFC to realize a WDM-PON system. These results are attractive as they demonstrate and motivate the possibility of using gain-switched VCSELs as OFC sources in future WDM-PON networks requiring enhanced channel capacity and stringent network latency monitoring to realize intelligent, simple, and power-efficient PON networks.