Simultaneously remove Phosphine, hydrogen sulfide and hydrogen Cyanide: Synergistic effect of micro-electrolysis and liquid-phase catalytic electrolysis

Zhao, Chenyang; Yuan, Yongheng; Qu, Guangfei; Li, Junyan; Liu, Guojun; Yuan, Zheng; Cheng, Yinhan; Ning, Ping

doi:10.1016/j.seppur.2023.125085

Cited by 2 publications

(1 citation statement)

References 38 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…It is therefore important to take steps to prevent the release of cyanide into the environment. Some cyanide removal methods have been proposed, based on chemical [4], physical [5], biological [6,7] and even adsorption [8] techniques. Adsorption has attracted more interest in cyanide removal from wastewater due to its simplicity and the absence of hazardous chemicals [9].…”

Section: Introductionmentioning

confidence: 99%

Cyanide removal by graphene-type oxidized biochar: kinetic study and adsorption isotherms

Yannick Daniel Djè,

Zoungranan Yacouba,

Dobi-Brice Kouadio Kouassi

et al. 2024

World J. Adv. Res. Rev.

View full text Add to dashboard Cite

The use of biomass to convert it into valuable chemicals has recently attracted the interest of researchers. In this study, graphene-type oxidized biochar was synthesized by calcination using oil palm (Elaeis guineensis) seed hulls of the hybrid variety dura x pisifera as the main carbon source. Graphene-like oxidized biochar (BOGp) was prepared from BGp by modification of the oxidation method described by Panicker and colleagues. The influences of mass variation, concentration and contact time were investigated, respectively. The study showed that for 0.1 g of BOGp used in 50 mL of a 1 mg/L cyanide solution, the elimination rate is 65%, for an equilibrium time of 60 minutes, and the elimination process is chemisorption, which follows the pseudo-second-order kinetic model. Absorption is described by the Freundlich isotherm, confirming multilayer adsorption. The BOGp characteristics were analyzed using modern analytical methods. Characteristic analysis of the BOGp results indicated that it is a low-moisture material with a high ash percentage, a density of 0.71 and a zero-charge point pH of 4. DRX analysis showed characteristic graphitic carbon peaks at 2θ ≈ 26.03° followed by peaks at 2θ ≈ 10° and 2θ ≈ 43° characteristic of oxidized graphitic carbon. Infrared analysis revealed OH and C=O functions confirming BOGp oxidation and C=C and CH2 groups corresponding to the skeletal vibration of the graphene sheet.

show abstract