Single particle flame-combustion studies on solid biomass fuels

Abstract

Combustion of solid biomass in large scale power generation has been recognized as a key technology for the transition to a decarbonized electricity sector in the UK by 2050. Much of the near-term forecast capacity is likely to be by the conversion of existing coal-fired pulverized fuel plant [1]. In such applications, it will be necessary to ensure that the combustion behaviour of the solid biomass fuels is engineered to match, as far as practical, that of the original plant design. While biomass feedstock characteristics vary considerably, one controllable variable for pulverized fuel is the size of the particles.Useful modelling for adaptation and design of boiler plant can be improved with more detailed measurement of the real behaviour of individual particles of the varying fuels. Typical power plant biomass fuels including pine, eucalyptus and willow with particle sizes ranging from up to 3mm [2] and with differing moisture content and aspect ratios were selected for study. Single particles were supported in a water-cooled cover and then exposed above a flame, simulating biomass combustion in a furnace.Measurements of ignition delay, volatile burning time and char burn-out time were undertaken using high speed image capture. Temperatures of the surrounding environment and near to the particle surface were measured with thermocouples and thermometric imaging. Thermo-gravimetric measurements on 2 separate samples complement the single particle measurements as a means of verifying the demarcation between the different stages of combustion and providing kinetic data.Analysis of the data identified correlations between the biomass fundamental characteristics, particle size, and the observed combustion profiles. Empirical expressions for the duration of each combustion stage have been derived. These have been validated with basic modelling including the predicted devolatilisation stage calculated by the FG-Biomass model [3].

An experimental study of single unconventional biomass pellets: Ignition characteristics, combustion processes, and artificial neural network modeling

“…Some studies are about the burning of micron‐sized biomass particles. On the basis of the experimental data of single‐particle combustion, Mason et al derived the empirical relationships between combustion characteristics (ignition delay, volatile flame duration, and char burn duration) and properties of biomass particles (size, moisture content, density, and shape). Riaza et al conducted a combustion experiment using coal (300 μm to 1 mm) and biomass particles (610 μm to 3 mm) in a device that was similar to that in Flower and Gibbins .…”

Have Technology Specific Measures for the UK Electricity Market Reform Gone Far Enough?

“…The aim is to encourage full biomass conversion as a transitional technology, and replace to RO's with CFD's [7].…”

Combustion Behavior of Single Pellets of Coal–Wood Mixtures in a Hot Gas Flow Field

“…A number of experiments were carried out on the combustion of single biomass particles around 1 mm in size. [29][30][31] Single pellets of wood and coal mixtures have not been investigated for sequential co-combustion processes or for burning characteristics at rapid heating rates.…”