Single switch Z source/quasi Z source DC-DC converters

Saravanan, V.; Sabitha, M.; Bindu, V.; Venkatachalam, K.; Arumugam, M.

doi:10.11591/ijape.v10.i1.pp68-79

Cited by 2 publications

(2 citation statements)

References 25 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The final designs were preferred based on helpfulness, realism, and existing resources. The Robot should be able to abundantly extinguish a test fire safely and safely while displaying the values of sensors on the LCD (33)(34). All these goals should be met while following size and weight constraints.…”

Section: Objectivementioning

confidence: 99%

Prototype for Automatic Fire Detection and Extinguishing Robot

Vemulapalli¹,

Madhavi²,

Azaharahmed³

2022

ECS Trans.

View full text Add to dashboard Cite

Fire mishaps are common nowadays, and at times it has become very challenging for firefighters to save personage entities. It became hard for a human being too constant supervision during accidental fire situations. Consequently, in such cases, a firefighting robot is handpicked. Particular robots are most fruitful in industries where the odds of unintentional fires are severe. Moreover, the initiated vehicle can recognize the existence of fire and extinguish it involuntarily by pumping out water. Temperature sensors and smoke sensors are used for the detection of fire. It contains a motor-driver module that controls the gesture of the robot. A relay circuit is handed down to direct the pump, and it automatically sprinkles water when the fire is noticed. The proposed robot also has an LCD that displays the temperature, smoke, and fire rate.

show abstract

Section: Objectivementioning

confidence: 99%

Prototype for Automatic Fire Detection and Extinguishing Robot

Vemulapalli¹,

Madhavi²,

Azaharahmed³

2022

ECS Trans.

View full text Add to dashboard Cite

show abstract

“…Unlike fossil fuels, renewable energy sources produce intermittent power. Using step-up DC-DC power converters, energy flow can be controlled efficiently with single stage power conversion [21]. A high gain non isolated bidirectional DC-DC converter suitable for PV systems is presented in [22] and it provides improved dynamic response.…”

Section: Introductionmentioning

confidence: 99%

Analysis of single switch step up DC-DC converter with switched inductor-switched capacitor cells for PV system

Gnanavadivel,

Kalarathi,

Prakash

2024

IJAPE

View full text Add to dashboard Cite

The presented work exhibits high gain and increased efficiency for DC-DC converter. Additionally, this topology significantly improves the voltage conversion ratio when compared with other DC-DC converters reported recently. The non-existence of high frequency transformer ensures compactness and low cost and henceforth, it is apt for clean energy applications. The analysis of the high gain converter in steady state is carried out in continuous conduction mode (CCM). Initially, the proposed converter performance is analyzed using MATLAB/Simulink platform and prototype of the same with a power rating of 200 V, 100 W is built and tested. The reliability and robustness of the converter is perceived from the experimental results and peak efficiency achieved is around 93%.

show abstract

Single switch Z source/quasi Z source DC-DC converters

Cited by 2 publications

References 25 publications

Prototype for Automatic Fire Detection and Extinguishing Robot

Prototype for Automatic Fire Detection and Extinguishing Robot

Analysis of single switch step up DC-DC converter with switched inductor-switched capacitor cells for PV system

Contact Info

Product

Resources

About