Sintering and thermomechanical behavior of a Low Temperature Co-fired Ceramic

Heux, Adrien; Antou, Guy; Pradeilles, Nicolas; Delhote, Nicolas; Kärnfelt, Camilla; Gallée, François; Maı̂tre, Alexandre

doi:10.1016/j.ceramint.2018.09.035

Cited by 6 publications

(2 citation statements)

References 32 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The densification of the material can also be affected by a temperature increase to the peak temperature [17]. During the firing process, crystalline phases are formed in the most common LTCC materials, like e.g.…”

Section: Introductionmentioning

confidence: 99%

See 1 more Smart Citation

Impact of firing temperature on insulating properties of Low Temperature Co-fired Ceramics

Dąbrowski

2020

Materials Science-Poland

View full text Add to dashboard Cite

In this paper, results of investigation on the impact of firing temperature on insulating properties of Low Temperature Cofired Ceramics are presented. Dissipation factor, volume resistivity and breakdown electric field intensity were determined for firing peak temperature in the range from 800 °C to 900 °C. The tests were performed for two commercial LTCC materials: 951 Green Tape (DuPont, USA) and SK47 (Keko, Slovenia). The results showed that the firing temperature had a significant effect on the dielectric loss factor, volume resistivity and lifetime at applied high voltage. No clear tendency was observed for dielectric strength in the analyzed firing temperature range.

show abstract

Section: Introductionmentioning

confidence: 99%

“…During the firing process, crystalline phases are formed in the most common LTCC materials, like e.g. 951 (DuPont) [14,18], A6M (Ferro) [15,16], 41111-G (ESL) [17]. Higher firing temperature results in higher rate of crystalline phase formation.…”

Section: Introductionmentioning

confidence: 99%