Sizing Procedure for System Hybridization Based on Experimental Source Modeling for Electric Vehicles

Abstract

Hybrid vehicles are now more common in response to increasing global warming. The hybridization of energy sources and energy storage units enables improving the sustainability, reliability, and robustness of power systems. To reach the objective of zero emissions, a proton exchange membrane hydrogen fuel-cell was utilized as an energy source. The aim of this research was to create an accurate optimal sizing procedure for determining the nominal rating of the necessary sources. We modeled the fuel cell and the battery pack using data from real experimental results to create the generic database. Then, we added data on the mission profile, system constraints, and the minimization target function. The mission profile was then analyzed by the sizing algorithm to determine optional minimum and maximum fuel cell ratings. Analyzing the optional solutions using the vehicle real time energy management system controller resulted in a set of solutions for each available rated fuel cell, and the optimal compatible battery in the revealed band successfully accomplished the route of the driving cycle within the system limitations. Finally, the Pareto curve represented the optimal finding of the sizing procedure. Ultimately, in contrast to previous works that utilize gross manufacturer data in the sizing procedure, the main research contribution and novelty of this research is the very accurate sizing results, which draw on real experimental-based fuel-cell and battery sizing models. Moreover, the actual vehicle real time energy management system controllers were used in the sizing procedure.

Topological Overview of Auxiliary Source Circuits for Grid-Tied Converters

“…A major requirement of the power converter is to employ capacitors on DC-BUS terminals for a variety of reasons, such as input/output power balancing, harmonics absorption, short-term period energy storage, and suppressing the VR [22][23][24][25]. Capacitor utilization is most common in power conversion systems, such as off-line converters, lighting drivers, full/hybrid electric propulsion systems [26], and a variety of renewableenergy applications [27]. The BEC is employed in a parallel connection to the DC-BUS terminals, as can be seen in Figure 1.…”

Optimized Design of a H2-Powered Moped for Urban Mobility

“…The potential of this design and appropriate control methods applied to the powertrains of e-moped FCH-LEVs has not been fully unveiled yet. In fact, only a few papers have studied the optimized design of FCHEVs in bikes [36,37], cars [38,39], and yard trucks [40]. Only a few prototypical examples of motorbikes [41] and e-moped FCHEVs exist [42].…”