Soil-particle and pore orientations during drained and undrained shear of a cohesive sandy silt–clay soil

Abstract

The orientations of particles, pores, and other constituents of an artificially made cohesive sandy silt–clay soil were studied to investigate how they change during drained and undrained shear. The results show that the orientation pattern before shearing is nearly random, although there may be some degree of preferred orientation caused by the overburden pressure. The degree of preferred orientation increases as the shearing increases until failure in both the drained and undrained tests and increases towards the failure plane. After failure, the degree of preferred orientation does not change considerably near the failure plane but does continue to increase away from it. The number of oriented particles, pores, and other constituents increases, but their averages stay about the same as the shearing continues after failure in the drained tests. The differences between the degrees of preferred orientations 5 and 10 mm away from the failure planes at different shear (horizontal) displacements are much less in the drained tests than in the undrained tests, indicating formation of a wider deformation zone in the drained tests. This is probably because particles in the drained tests have enough time to respond to the applied shear stresses and change their orientation. This may explain why deformations occur in wide zones along tectonically active creeping (aseismic) faults, whose mechanisms are analogous to those of drained shear tests, and in narrow zones along seismic faults, whose mechanisms are analogous to those of undrained shear tests.Key words: shear test, soil structure, soil fabric, preferred orientation, seismic, aseismic.

Pore changes in an illitic clay during one-dimensional compression

“…Pires et al, 2008) but with also some recent examples in soil mechanics (e.g. Cetin and Söylemez, 2004;Gao et al, 2020).…”

Improvement of Geotechnical Properties of Clayey Soil Using Biopolymer and Ferrochromium Slag Additives

“…Most of the samples did not have a clear or pronounced failure point exhibiting strain-hardening behavior, which is typical of cohesive soils like clays. Here, the failure point was taken as the stress corresponding to 15% shear strain as recommended by [54,55], and ASTM D 3080-04 [45]. Figure 8 also shows the vertical (volumetric) deformation changes as the samples were sheared under the selected normal pressures.…”

Research on Dynamic Stress–Strain Change Rules of Rubber-Particle-Mixed Sand

“…The hysteresis curve of the soil mass is the basis of studying the dynamic triaxial characteristics. The characteristic dynamic parameters of the soil mass, including the dynamic elastic modulus and the damping ratio, could be obtained by the quantitative characteristic analysis [14] of the hysteresis curves.…”