1964
DOI: 10.1021/je60021a048
|View full text |Cite
|
Sign up to set email alerts
|

Specific Volumes of n-Alkanes.

Abstract: for six alkyltellurium compounds. These averages exclude three single occurrences: one tertiary mercaptan, one double branched alkyl selenide and one double branched alkyl diselenide.

Help me understand this report

Search citation statements

Order By: Relevance

Paper Sections

Select...
1
1
1
1

Citation Types

2
60
1

Year Published

1975
1975
2012
2012

Publication Types

Select...
6
2

Relationship

1
7

Authors

Journals

citations
Cited by 148 publications
(63 citation statements)
references
References 0 publications
2
60
1
Order By: Relevance
“…The samples were further distilled and degassed before use and the purity determined chromatographically was found to be better than 99.9 %. The density of liquid n-heptane has been taken from the work of Doolittle [21] and has a reported uncertainty of _ 0.2 %. Table III lists the results of the measurements of the viscosity of n-heptane determined with the high-pressure viscometer for three isotherms, whereas the values determined in the low-pressure for two isotherms have been reported earlier.…”
Section: Resultsmentioning
confidence: 99%
See 1 more Smart Citation
“…The samples were further distilled and degassed before use and the purity determined chromatographically was found to be better than 99.9 %. The density of liquid n-heptane has been taken from the work of Doolittle [21] and has a reported uncertainty of _ 0.2 %. Table III lists the results of the measurements of the viscosity of n-heptane determined with the high-pressure viscometer for three isotherms, whereas the values determined in the low-pressure for two isotherms have been reported earlier.…”
Section: Resultsmentioning
confidence: 99%
“…Thus, we obtained from the inequalities expressed by Eq. (5), and co ~ #/e2pR 2 (20) co > e#/pR 2 (21) which provide upper and lower bounds in the space (R, co) for specific ranges of p and p for the fluid as well as the obvious condition e ~< 1. In addition, the condition given by Eq.…”
Section: Design Constraintsmentioning
confidence: 99%
“…In this project we derive a new set of pure-component PC-SAFT parameters by fitting the equation to high temperature, high pressure (HTHP) density data present in the literature [13,23,55,65,66] that covers almost the entire pressure and temperature ranges of interest for deep reservoirs. Sub-critical density data are not used to obtain these new parameters.…”
Section: Hthp Pcsaftmentioning
confidence: 99%
“…, toluene [23], n-heptane [55] and n-decane [23] Table 3: Data obtained in this study for the calibration of the transducer used with the view cell (P view cell) against the Viatran-calibrated pressure transducer (P Viatran ) and a Heise gauge at room temperature 18 Table 4: Decane density data obtained at 250°C at VCU and estimates of the error in the density from each term in Equation (8). Only select data are shown to demonstrate the impact of each term.…”
mentioning
confidence: 99%
“…Of particular concern was the accuracy of data for the higher molecular weight wax compounds. For liquid densities, data over a wide range of temperatures and pressures are available from Doolittle up to a carbon chain length of 40 [1]. Other density data are available for even higher molecular weight alkanes (up to C 94 ), but the measurements are limited to small temperature and pressure ranges.…”
Section: Task 1c Design and Construction Of New Apparatusmentioning
confidence: 99%