SSI‐induced seismic earth pressures on an integral abutment bridge model: Experimental measurements versus numerical simulations and code provisions

Abstract

Integral abutment bridges (IABs) generate strong soil–structure interaction (SSI) effects due to their high structural stiffness and transmission of inertial and thermal loads generated at the deck directly to the abutments. Despite an increasing number of experimental and numerical studies available in the literature, there is a lack of consolidated methodologies to model dynamic SSI phenomena for IABs, particularly in seismic regions where uncertainties associated with the induced ground motions render the problem harder to tackle. This study proposes an advanced strategy to model the seismic response of IABs, accounting for dynamic interaction between the structure, the abutment and the foundation, including piles and earth retaining walls. To this end, detailed finite‐element studies were carried out employing OpenSees to simulate a recent experimental campaign on a scaled IAB model in a soil container (SERENA) carried out at EQUALS Lab, University of Bristol, in the framework of SERA/H2020 project. An extensive dataset in terms of recorded accelerations, displacements, strains and settlements are available from these tests, including earth pressures which are back‐calculated from bending strain measurements. The objectives of this paper are threefold: firstly, the model parameters are explored and assessed critically by comparing the results from the numerical simulations against the experimental data; secondly, once the model is deemed sufficiently representative of the experiments, earth pressures are obtained numerically, as these are not directly measured in the tests; thirdly, the estimated static and dynamic earth pressures on the abutment wall are compared with the predictions of two simplified analytical procedures currently under consideration for inclusion in the new Eurocode 8. The results indicate that records and predictions match well for frequencies of up to 40 Hz at model scale (about 8 Hz in prototype scale) and confirm that the proposed modelling strategy can be used in practical applications. The quasi‐elastic model proposed in this study is shown to provide dependable predictions for cases involving moderate strains in real‐life applications.