To cite this version:Arnaud Fregeac, Florence Ansart, Serge Selezneff, Claude Estournès. Relationship between mechanical properties and microstructure of yttria stabilized zirconia ceramics densified by spark plasma sintering.OATAO is an open access repository that collects the work of Toulouse researchers and makes it freely available over the web where possible Any correspondence concerning this service should be sent to the repository administrator: tech-oatao@listes-diff.inp-toulouse.fr This is an author's version published in: http://oatao.univ-toulouse.fr/24381
To cite this version:Fregeac, Arnaud and Ansart, Florence and Selezneff, Serge and Estournès, Claude Relationship between mechanical properties and microstructure of yttria stabilized zirconia ceramics densified by spark plasma sintering. (2019) Ceramics International, 45 (17Porous ceramics are widely used for many applications such as filters, insulators, electrodes for SOFC, membranes or bone scaffolds, with porosity in the typically range of 20-50%vol. The functionality of those materials comes at the expense of the degradation of their mechanical properties which are highly impacted by the rate, distribution, shape and size of the porosity. Among them tetragonal stabilized zirconia (TSZ) is one of the most industrially used; it is sometime called: "the ceramic steel" since in its dense state it exhibits the highest toughness for ceramics. It is known that the porosity has a huge impact on the thermo-mechanical properties of refractory ceramics as Yittria Stabilized Zirconia (YSZ). This study aims to capitalize the mechanical properties as a function of porosity to provide future applications and ensure the behavior in service of thermal barrier coating.In the present paper, the correlation between the microstructure and the mechanical properties such as Young modulus, hardness and strength of YSZ ceramics obtained by Spark Plasma Sintering (SPS) was investigated. Two types of YSZ powder, a nanometric one from Tosoh and a micrometric one obtained by sol-gel route were studied to prepare homogeneous mesoporous or oriented macroporous microstructure by partial sintering. SPS parameters have been determined and optimized to manage the porosity rate. Furthermore, a bimodal microstructure can be obtained, by mixing both powders, allowing the formation of linking bridges between the microporous zone and the nanopowder during sintering. The macroporous ceramics have lower Young modulus, hardness and strength than mesoporous ones. These characteristics are discussed in the paper taking into account the differences between microstructure and contacts between particles with various form factors. Thus, it is clearly evidenced that the morphology of raw powders and the level of porosity are key parameters to optimize the mechanical properties of such porous material.