Strain determination of self-adhesive resin cement using 3D digital image correlation method

Abstract

Introduction/ObjectiveIn an attempt to simplify dental procedures, a new group of resin cements, self-adhesive resin cements (SARCs), have been introduced. Performance of SARCs can widely vary. One of the main reasons of adhesion failure is polymerization shrinkage. The aim of this study was to determine, evaluate, and measure strain field of self-adhesive dual cure resin cement during polymerization in self-cure mode using 3D digital image correlation (DIC) method. Methods The self-adhesive Maxcem Elite (Kerr, Orange, CA, USA) cement was tested in five cylindrical samples (5 mm in diameter and 2 mm in thickness) prepared by filling plastic ring-type molds. Digital images were recorded immediately after sample preparation. Results Non-uniform strain distribution was found in resin cement with higher strain values along the periphery (up to 15%) and lower strain values in central parts (around 4%) of each sample. Conclusion It can be concluded that DIC is a powerful tool for full-field strain measurements in material characterization.

3D Digital Image Correlation Analysis of the Shrinkage Strain in Four Dual Cure Composite Cements

“…Using two cameras system, 3D-DIC technique provided sufficient data about out-of-plane shrinkage strain [15]. An advantage of the 3D-DIC method over other methods is the ability of full-field strain measurement [9, 20–23]. These methods excluded peripheral section (Section 0) although the peripheral strain has to be considered when interpreting the overall strain.…”