Strategies for swift automated pick-and-place operations of multiple large-sized layers of reinforcement - a critical review

Abstract

For the application of composite materials to become more widespread and replace traditional materials their manufacturing processes and final products will need to be competitive and be e.g. lighter, stronger or stiffer and quicker, easier or more cost-efficient to produce than traditional materials. The state of the art for pick-and-place operations for the manufacturing of composite parts focuses on handling single lab-sized layers at undisclosed speeds. The process could however be more competitive by being able to handle more and larger layers in a faster manner than currently presented in research. The aim of the paper is to evaluate the existing pick-and-place strategies on their suitability for the swift automated handling of multiple large-sized layers of reinforcement. The review shows that many of the existing techniques could be suitable for different scenario's and discusses which factors are to be taken into account when dealing with large layers, more than one layer or rapid handling.

Towards automation of wind energy rotor blade production: a review of challenges and application examples

“…Storing the textile after the cutting process is a necessary process step before lay-up. For small tailored layers it is often carried out by the so-called pick-and-place process: The tailored layer is picked up by special grippers from the flat cutting table and held up to the lay-up position [95,97,[104][105][106]. Due to the limp material characteristics of technical textiles and the resulting Figure 5.…”

Analysis of the performance of a new concept for automatic draping of wide reinforcement fabrics with pre-shear: A virtual prototyping study

“…For aerospace applications, see e.g. Elkington et al [3] , Szcesny et al [4] , and Ellekilde et al [5] , with other systems discussed in the review paper by de Zeeuw et al [6] .…”

Hybrid vacuum-robotic forming of reinforced composite laminates

“…Automated composite manufacturing processes can be categorised broadly into two approaches; those that build up the finished material by laying down fibres in the form of narrow unidirectional tapes, as reviewed by Lukaszewicz et al, 2012 1 or those that use broadgood sheet materials, as reviewed by De Zeeuw et al, 2020 2 and Elkington et al, 2017. 3 Tape based methods such as Automated Fibre Placement (AFP) can be effective for forming flat or simply curved shapes, but complex geometries featuring double curvature, tight radii and negative volumes may not be viable.…”