Suitability of Unmanned Aerial Vehicles for Cadastral Surveys

Abstract

Cadastral surveys in Ghana often employ well known surveying equipment such as Total Station andGNSSreceivers or a combination of both. These survey techniques are well-established and widely accepted. However, there are limitations in certain areas. In situations where difficult terrain and inaccessible areas and dense vegetation are encountered or when surveyor’s life may be at risk, Unmanned Aerial Vehicles (UAVs) could be used to overcome the limitations of these well-established survey instruments. This research used high resolution images from UAV (DJI Phantom 4) to survey plots within the University of Mines and Technology land area. Coordinates of the boundary points were extracted using Agisoft Photoscan.GNSSreceivers were also used to survey the land and the same boundary point coordinates obtained and compared. This enabled the establishment of accurate ground control points for georeferencing. The coordinates obtained from both UAV andGNSSSurveys were used to prepare cadastral plans and compared. The difference in Northings and Eastings from UAV andGNSSsurveys were +0.380 cmand +0.351 cmrespectively. These differences are well within tolerance of +/-0.9114 m(+/-3 ft) set by the Survey and Mapping Division (SMD) of the Lands Commission for cadastral plans production. This research therefore concludes that high resolution images from UAVs are suitable for cadastral surveying. Keywords: Unmanned Aerial Vehicles, Drones, Global Navigation Satellite Systems, Cadastral Surveys

Assessment of positional accuracies of UAV-based coordinates derived from orthophotos at varying times of the day- A case study

“…While their application in military operations was perhaps their first use, the industry of civil UAVs has been increasing steadily, and has more than doubled since 2008 (Leitão et al, 2016). UAVs are now used in land surveying (Mantey and Tagoe, 2019;Manyoky et al, 2011;Volkmann and Barnes, 2014), precise agriculture for crop monitoring, spraying and health assessment of vegetation, in archaeology for documentation of excavations (Thomas, 2016) or in photogrammetry for 3D modeling (Colomina and Molina, 2014).…”

Comparative Analysis of Stockpile Volume Estimation using UAV and GPS Techniques

“…It is very stressful, tedious and time consuming when collecting data for daily, weekly and monthly volume estimation using the conventional techniques. Unmanned Aerial Vehicle (UAV), commonly known as drone is an emerging technology which is an aircraft without human pilot on board and has its application also in the Mine (Mantey and Tagoe, 2019;Miljkovi´c et al, 2017;Cryderman et al, 2014;Merz and Chapman, 2011;Everaerts, 2008;Valavanis, 2008). UAV technology has the potential to reduce the stress and the manual effort involved in surveying, mapping and data collection (Mantey and Tagoe, 2019;Rathore andKumar, 2015 Manyoky et al, 2011).…”

“…Unmanned Aerial Vehicle (UAV), commonly known as drone is an emerging technology which is an aircraft without human pilot on board and has its application also in the Mine (Mantey and Tagoe, 2019;Miljkovi´c et al, 2017;Cryderman et al, 2014;Merz and Chapman, 2011;Everaerts, 2008;Valavanis, 2008). UAV technology has the potential to reduce the stress and the manual effort involved in surveying, mapping and data collection (Mantey and Tagoe, 2019;Rathore andKumar, 2015 Manyoky et al, 2011). UAVs are becoming increasingly important for the purpose of 3D mapping or volume computation in an open pit mining industry (Park et al, 2016;Cryderman et al, 2014;Witayangkurn et al, 2011).…”