Surface treatment of incrementally produced components in FFF (Fused Filament Fabrication) technology

Mrówka, Maciej; Machoczek, Tomasz; Szymiczek, M.; Gągol, Przemysław; Duda, Sławomir; Marcoll, Łukasz

doi:10.14314/polimery.2020.1.7

Cited by 3 publications

(1 citation statement)

References 17 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Therefore, as the layer height increases, the surface quality gets worse. Mrówka et al 15 identified the same behavior when analyzing layer heights between 0.06 and 0.4 mm after printing acrylonitrile butadiene styrene (ABS) and PLA parts. Buj-Corral et al 16 reached the same conclusion in their studies of the printing of PLA when using layer heights between 0.05 and 0.25 mm.…”

Section: Introductionmentioning

confidence: 75%

Examining the surface quality of inner and outer surfaces in material extrusion printed samples

Río

Carou

Pereira

2023

Proceedings of the Institution of Mechanical Engineers, Part L:

View full text Add to dashboard Cite

This article presents an experimental study of the material extrusion process to examine the impact of less-analyzed factors on surface roughness, not including the commonly known layer height. The study also gives attention to the inner surfaces of printed samples. The design of experiments used a fractional factorial design with five two-level factors: bed temperature, fan percentage, printing speed, printing temperature, and wall thickness. Thus, the purpose of the design is screening. A two-dimensional contact profilometer was used to measure the surface roughness. Generally, the inner faces of the printed samples showed lower surface roughness. In addition, four analysis of variance showed that wall thickness (for Ra and Rz) and printing speed (for Ra) are significant for the outer and inner surfaces, respectively. As the wall thickness increased, the surface roughness decreased. Meanwhile, the lower the printing speed, the worse the surface quality on the inner faces.

show abstract

Section: Introductionmentioning

confidence: 75%