Sustainable Development of Renewable Energy resources. Biomass Cogeneration Plant

Cimdiņa, Ginta; Slišāne, Dzintra; Ziemele, Jeļena; Vitolins, Valdis; Vīgants, Ģirts; Blumberga, Dagnija

doi:10.3846/enviro.2014.256

Cited by 1 publication

(2 citation statements)

References 11 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…However, special focus has been placed on the selection of criteria. The criteria that are used for the multiple-criteria analysis are energy efficiency, operational costs, investment costs, load coefficient; see the authors' article [37] for more details.…”

Section: Multiple-criteria Decision Analysis Methodologymentioning

confidence: 99%

“…In his proposal, the capacity of the DH network was used as dynamic heat storage and this solution was recognized as feasible. Two radically contradictory solutions when choosing the installed capacity of CHP are studied by Cimdina et al [37]: 1) compliance with the base load of the DH system; and 2) compliance with the optimal heat load of the DH system during the whole year.…”

Section: Introductionmentioning

confidence: 99%

See 1 more Smart Citation

Methodologies Used for Scaling-up From a Single Energy Production Unit to State Energy Sector

Cimdiņa

Timma

Veidenbergs

et al. 2015

Environmental and Climate Technologies

Self Cite

View full text Add to dashboard Cite

In a well-functioning and sustainable national energy sector, each of its elements should function with maximum efficiency. To ensure maximum efficiency and study possible improvement of the sector, a scaling-up framework is presented in this work. The scaling-up framework means that the starting point is a CHP unit and its operation, the next step of aggregation is in a district heating network, followed by a municipal energy plan and finally leading to a low carbon strategy. In this framework the authors argue, that the successful, innovative practices developed and tested at the lower level of aggregation can be then transferred to the upper levels of aggregation, thus leading to a scaling-up effect of innovative practices. The work summarizes 12 methodologies used in the energy sector, by dividing these methodologies among the levels of aggregation in a scaling-up framework.Environmental and Climate Technologies ____________________________________________________________________________ 2015 / 15 6 electricity can be held together, but also because fuel savings can be achieved and therefore more an efficient overall conversion process is possible.Çakir et al. [9] estimate that fuel savings via a cogeneration regime can reach 50 %. Since CHP plants and biofuel production require the same feedstock, Leduc et al. [10] investigated whether the use of biomass should be supported in the EU. The results showed that the CHP plants are preferred over biofuel production plants in cases when carbon costs more than 50 EUR per tCO2 and the support for biofuel is below 10 EUR per GJ. Moreover, the highest potential for both biofuel and CHP was found in the countries around the Baltic Sea, Austria, Czech Republic, Hungary and Poland. The sustainable development of biomass CHP plants in Latvia was studied by Cimdina et al. [11].Nevertheless the installation of CHP and the conversion of energy production units to renewables are not enough. In sustainable energy production systems, the analysis of operational performance is vital. The literature review traces a wide range of factors affecting the performance of the cogeneration power plant. Cimdina et al. [12] determines the essential factors of the operation performance in biomass cogeneration power by presenting quantitative equations.Biomass CHP can be assessed using various indicators such as efficiency [13], primary energy savings [14], emergy efficiency [10], internal rate of return (IRR) and net present value (NPV) [15], as well as the costs of heat and power production [16]. Nevertheless, traditionally applied assessment methods of energy and mass flows and economic analysis do not provide an integral assessment. In this case another methodology should be applied. Emergy and exergy analysis could serve as such an integral assessment method [17].Exergy is defined as the maximal useful work obtained from a system while the system interacts with environment. Nowadays energy and exergy analyses are done for power plants [18] and for various energy technologies, such as i...

show abstract

Section: Multiple-criteria Decision Analysis Methodologymentioning

confidence: 99%

Section: Introductionmentioning

confidence: 99%