Synthesis and characterization of dental composites

Djustiana, Nina; Greviana, Nadia; Faza, Yanwar; Sunarso, Sunarso

doi:10.1063/1.5021191

Cited by 10 publications

(10 citation statements)

References 25 publications

Supporting

Mentioning

Contrasting

Unclassified

Order By: Relevance

“…The amino group of chitosan is predicted to create bonding between filler and resin matrix. 8,13 Micro-Vickers hardness in Figure 4 shows means value of sample A, B, and C were 31.9 VHN, 25.63 VHN and 28,9 VHN respectively. However, there was no significant differences of hardness value (p-value > 0.05) between those samples.…”

Section: Discussionmentioning

confidence: 99%

See 1 more Smart Citation

Hardness evaluation of dental composites fabricated from the uniform size and well-distributed zirconia-alumina-silica fillers with sol-gel technique

Hakim¹,

Hasratiningsih

Djustiana

et al. 2018

Padjadjaran J Dent

Self Cite

View full text Add to dashboard Cite

Introduction: Several factor limits of services of dental composite have triggered further improvement. ZrO2-Al2O3-SiO2 system as filler of dental composite had been developed with sol-gel technique. Ultrasonic homogeniser were reported to change the particle size ditribution or shape. Unifom size and distribution of particle is believed to help define the behavior of hardness properties. Methods: The study was an laboratory experimental design. Filler ZrO2-Al2O3-SiO2 system were developed via sol-gel methods. Post calcination process, filler were immerse in ethanol and applied with ultrasonic homogeniser, with various amplitude i.e 50 rpm, 60 rpm and 80 rpm then named sample A, B, and C. XRD, SEM anda PSA were used to characterize of filler system. Subsequent filler were used to fabricate dental composite then evaluate the hardness value using micro-hardness tester. One–way ANOVA was used to analysis the statistical result of hardness value. Results: XRD pattern of three sample were similar in which tetragonal zirconia was prominent (57-61 %) followed by monoclinic zirconia (24-25%) and amorphous (15-17 %). While, SEM and PSA characterization showed amplitude 50 rpm (sample A) produce more uniform size and well-distributed particle filler than the others. In contrary, sample B and C showed higher peak in PSA results. It means there was dominating of filler with particular size. However, the hardness value did not show significant differences between those filler (p>0,05). Conclusion: Dental composite that contain of different uniformity and distribution of filler ZrO2-Al2O3-SiO2 system has no significantly differences of hardness value.

show abstract

Section: Discussionmentioning

confidence: 99%

“…1,6,7 Dental composite consist of resin matrix, filler, coupling agent, initiator and accelerator system (polymerization). 8 Filler is a component that may affect the characteristic of dental composite. 9,10 Zirconia, alumina and silica were frequently used as a composite filler.…”

Section: Introductionmentioning

confidence: 99%

Hardness evaluation of dental composites fabricated from the uniform size and well-distributed zirconia-alumina-silica fillers with sol-gel technique

Hakim¹,

Hasratiningsih

Djustiana

et al. 2018

Padjadjaran J Dent

Self Cite

View full text Add to dashboard Cite

show abstract

“…Resin komposit adalah material sewarna gigi yang saat ini diminati masyarakat sebagai bahan tambal restorasi karena nilai estetik yang baik dan dapat digunakan pada gigi anterior dan posterior [3]. Penggunaan restorasi resin komposit pada beberapa tahun terakhir telah meningkat karena tuntutan pasien yang lebih tinggi untuk perawatan estetik dan biokompatibilitas yang lebih baik [4].…”

Section: Pendahuluanunclassified

The Effect of Composite Brushing with Different Types of Toothpaste on Stain Due to Immersion in Coffee, Tea and Cuko Pempek Water

Fitria

Riyadi

2022

jkg. jurnal. kesehatan. gigi

View full text Add to dashboard Cite

Composite is a tooth-colored filling material that can change color by extrinsic staining such as coffee, tea and cuko pempek. Abrasive toothpaste can reduce stains but increase surface roughness. This study aims to determine the effect of the type of toothpaste for brushing on the formation of stains caused by coffee, tea and cuko pempek. This research is a quasi-experimental with pre and post control group design. 39 composite discs with a diameter of 1 cm and a thickness of 5 mm were prepared and divided into several groups, 1 group of negative control without treatment, 3 groups of immersion. Each immersion group was divided into 4 brushing groups, namely without brushing, brushing without toothpaste, brushing with abrasive paste and brushing with non-abrasive paste. Pre and post treatment discs were photographed and color changes were assessed using the CIE L*a*b and E system. Friedman, Kruskall Wallis and Mann Whitney U non-parametric analysis test was used to compare color values and color differences within groups and between groups. Based on this study, it can be concluded that there were significant color changes before and after the soaking treatment with coffee, tea and cuko pempek. The color change in coffee was significantly greater than that of tea and cuko pempek. There was no significant difference in color change between tea and cuko pempek. Conclusion: Brushing with toothpaste Keywords: composite; coffee; tea; cuko pempek; CIE LAB

show abstract

“…Various efforts have been made to develop and produce composites by acting on Indonesia's natural resources, such as using zircon sand as a filler. 3,4 Filler is one of the components of composite resin that is widely studied due to its role in the mechanical properties of composite resin. 5,6,7 Diametral tensile strength (DTS) is the important mechanical properties of composite resins as restorative materials.…”

Section: Introductionmentioning

confidence: 99%

<strong>Effect of 3-methacryloxypropyltrimethoxysilane on diametral tensile strength of rice husk silica-based dental composite </strong>

et al. 2022

Self Cite

View full text Add to dashboard Cite

Introduction: Rice husk silica has been studied as a filler in dental composite, however, the mechanical properties of the resulting composites are below the commercial due to the poor surface modification between silica and resin matrix. 3-methacryloxyprpyltrimethoxysilane (MPTS) is one of the coupling agents that are effective to modify the silica surface. The purpose of this study to analyze the effect of MPTS on the diametral tensile strength (DTS) of the self-made composite using rice husk silica. Methods: The research type of this study was an experimental research laboratory. The samples (26 samples) were divided into two groups, namely the test group (using MPTS-modified silica) and the control group (using non-modified silica). The samples were cylindrical in shape with a diameter of 6.0 ± 0.1 mm and a height of 3.0 ± 0.1 mm according to ANSI/ADAS No. 27, 1993 and ISO 4049, 1988. The Fourier Transform Infrared (FTIR), HORIBA, was used to characterize the MPTS grafting on the silica surface. The DTS value is measured by Universal Testing Machine (UTM), Lloyd LRX Plus. Results: FTIR presents the additional peak of carboxyl and methacryloyl group at 1716, 1555, and 1410 cm-1 wavenumber, respectively in MPTS-modified silica. The DTS value of the test group was 43.40 ± 4.43 MPa and the control group was 25.80 ± 2.63 MPa. The test group was significantly higher than the control group (p-value = 0.001). Conclusion: The MPTS is effective to enhance the DTS value of rice husk silica-based composite.Keywords: Rice husk silica; dental composite; diametral tensile strength; 3-methacryloxypropyltrimethoxysilane.

show abstract

Synthesis and characterization of dental composites

Cited by 10 publications

References 25 publications

Hardness evaluation of dental composites fabricated from the uniform size and well-distributed zirconia-alumina-silica fillers with sol-gel technique

Hardness evaluation of dental composites fabricated from the uniform size and well-distributed zirconia-alumina-silica fillers with sol-gel technique

The Effect of Composite Brushing with Different Types of Toothpaste on Stain Due to Immersion in Coffee, Tea and Cuko Pempek Water

<strong>Effect of 3-methacryloxypropyltrimethoxysilane on diametral tensile strength of rice husk silica-based dental composite </strong>

Contact Info

Product

Resources

About