T-3-4-2 Behavior of two kinds of Particles in Rotary Barrel

Kawamoto, Yoshihiro; Kataoka, Masumi; Uekusa, Masahiko; Terumichi, Yoshiaki

doi:10.1299/jsmeacmd.2002.278

Cited by 3 publications

(1 citation statement)

References 0 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…In the wet condition, a small percentage of the media had a tangential to normal force ratio approximately equal to the measured dynamic coefficient of friction between media, which indicates that there have mutual sliding [29]. By DEM software, the change rules of contact forces with different revolution ratio and filling ratio of media and parts are obtained, which is consistent to experiment results [30][31][32][33][34]. From many experiments in spindle finishing, the relationship between finishing depth of parts and material removal ratio is acquired, which implies force influence to finishing effect and is helpful for parameters selection [35].…”

Section: Mechanism and Modelssupporting

confidence: 81%

Development Status and Trends of Mass Finishing Processes

Yang

et al. 2014

KEM

View full text Add to dashboard Cite

Mass finishing processes have widely industrial application, and in most conditions these processes are used with empiricism and trial and error. Based on basic concept of mass finishing, its category is presented. Main aspects of motion and force analysis, material removal model, equipment and consumables, process experiments and industrial application are induced. Finally, development trends are recommended from quantified models, process database, new mass finishing processes and surface integrity. This will provide full investigation and further development and research to improvement part surface integrity.

show abstract