The appraisal of surface orbital vibrators with buried geophone array for permanent reservoir monitoring

Abstract

Time-lapse seismic is one of the main methods for monitoring changes in reservoir conditions caused by production or injection of fluids. One approach to time-lapse seismic is through permanent reservoir monitoring, whereby seismic sources and/or receivers are permanently deployed. Permanent reservoir monitoring can offer a more cost-effective and environmentally friendly solution than traditional campaign-based surveys that rely on temporarily deployed equipment while facilitating more frequent measurements. At the CO2CRC Otway Project, surface orbital vibrators were coupled to a buried geophone array to form a permanent reservoir monitoring system. These are fixed position seismic sources that provide both P and S waves using induction motor-driven eccentric masses. After an initial injection of CO 2 in February 2016, five months of continuous seismic data were acquired, and reflection imaging was used to assess the system performance. Analysis of the data showed the effects of weather variations on the near-surface conditions and the sweep signatures of surface orbital vibrators. Data processing flows of the continuous data was adapted from Vibroseis four-dimensional data processing flows. Ground roll proved a significant challenge to data processing. In addition, variations in the surface wave pattern were linked to major rainfall events. For the appraisal of surface orbital vibrators in imaging, a Vibroseis four-dimensional monitor survey data with similar geometry was also processed. Surface orbital vibrators are observed to be reliable sources with a potential to provide a repeatable signal, especially if the ground roll should fall outside the target window of interest. To guide future permanent reservoir monitoring applications, a repeatability analysis was performed for the various key data processing steps.