The development of heat‐resistant and salt‐tolerant foam with betaine surfactants

Abstract

A modified instrument was designed to evaluate foam properties under high temperature and pressure. The type and molar ratio of betaine surfactants were screened to develop the heat-resistant and salt-tolerant foam for Tahe oilfield (130 C, 220 g/L), and the effects of temperature and pressure on foam properties were also investigated. The synergism between surfactants and the enhanced oil recovery (EOR) mechanism of foam flooding in fractured-vuggy reservoirs were studied. Experimental results showed the developed foam had excellent foaming ability and foam stability when the lauramidopropyl hydroxyl sulfobetaine (LHSB): erucic amide propyl betaine (EAB) molar ratio ranged from 1:1 to 1:2 (initial foam volume was 392 ml when the molar ratio was 1:1, drainage half-time was 5.75 min and foam half-time was 72 min when the molar ratio was 1:2 at 130 C and 2 MPa). The synergistic effect was found to reach its maximum when the LHSB:EAB molar ratio ranged from 1:1 to 1:2 according to interaction parameters, which agreed with the results of foam properties. Foam stability was found to considerably increase with increasing pressure, but decrease with increasing temperature. However, temperature and pressure were found to have consistent effects on foaming ability, that is, the foaming ability increased with increasing temperature and pressure. The flooding test showed foam flooding exhibited better sweep efficiency and higher recovery ratio in the fractured-vuggy model than gas flooding and water flooding. This could be because injected foam did not channel through the top (or bottom) path due to its high viscosity and moderate density.