The Effect of Heat Treatment on the Sol–Gel Preparation of TiO2/ZnO Catalysts and Their Testing in the Photodegradation of Tartrazine

Abstract

This study aims to synthesize TiO2/ZnO powders and to study the effect of heat treatment on their photocatalytic ability against the Tartrazine anionic dye. The as-obtained powders with the following compositions—90TiO2/10ZnO and 10TiO2/90ZnO (mol%)—were obtained by the sol–gel technique. The prepared gels were annealed at 500 °C and 700 °C and subsequently characterized by XRD, UV–Vis, and SEM methods. The single crystalline phase of TiO2, which has been detected at up to 500 °C is anatase, while for ZnO, it is the hexagonal wurtzite structure. Further increases in the temperature (700 °C) led to the appearance of rutile in the samples. The SEM analysis demonstrated that the binary oxide materials had irregular shaped particles with a tendency to agglomerate. The UV–Vis spectra of the gels exhibited a red shift in the cut-off of the 90TiO2/10ZnO sample compared with pure Ti(IV) butoxide. Photocatalytic tests showed that the investigated samples possessed photocatalytic activity toward Tartrazine. Compared with TiO2, the prepared TiO2/ZnO photocatalysts showed superior properties in the photodegradation of a Tartrazine water solution. The target photocatalysts’ enhanced photocatalytic activities can be explained by their reduced band gap energy, improved surface physicochemical characteristics, separation of photo-induced electron–hole pairs, and lowered recombination rate. Higher photocatalytic activity was observed for powders annealed at 500 °C, with the 10TiO2/90ZnO (mol%) sample exhibiting the highest photocatalytic degradation of the used organic dye.