The Effect of Surface Defects on the Cyclic Fatigue Fracture of HEROShaper Ni-Ti rotary files in a Dynamic Model: A Fractographic Analysis

Abstract

This in vitro study examined the effect of surface defects on cutting blades on the extent of the cyclic fatigue fracture of HEROShaper Ni-Ti rotary files using fractographic analysis of the fractured surfaces. A total of 45 HEROShaper (MicroMega) Ni-Ti rotary files with a #30/.04 taper were divided into three groups of 15 each. Group 1 contained new HEROShapers without any surface defects. Group 2 contained HEROShapers with manufacturing defects such as metal rollover and machining marks. Group 3 contained HEROShapers that had been clinically used for the canal preparation of 4-6 molars. A fatigue-testing device was designed to allow cyclic tension and compressive stress on the tip of the instrument whilst maintaining similar conditions to those experienced in a clinic. The level of fatigue fracture time was measured using a computer connected the system. Statistical analysis was performed using a Tukey' s test. Scanning electron microscopy (SEM) was used for fractographic analysis of the fractured surfaces. The fatigue fracture time between groups 1 and 2, and between groups 1 and 3 was significantly different (p < 0.05) but there was no significant difference between groups 2 and 3 (p > 0.05). A low magnification SEM views show brittle fracture as the main initial failure mode. At higher magnification, the brittle fracture region showed clusters of fatigue striations and a large number of secondary cracks. These fractures typically led to a central region of catastrophic ductile failure. Qualitatively, the ductile fracture region was characterized by the formation of microvoids and dimpling. The fractured surfaces of the HEROShapers in groups 2 and 3 were always associated with pre-existing surface defects. Typically, the fractured surface in the brittle fracture region showed evidence of cleavage (transgranular) facets across the grains, as well as intergranular facets along the grain boundaries. These results show that surface defects on cutting blades of Ni-Ti rotary files might be the preferred sites for the origin of fatigue fracture under experimental conditions. Furthermore, this work demonstrates the utility of fractography in evaluating the failure of Ni-Ti rotary files. [J Kor Acad Cons Dent 32(2):130-137, 2007]

Comparative analysis of various corrosive environmental conditions for NiTi rotary files

“…Fracture caused by fatigue failure mechanism occurs due to crack initiation at the cutting surfaces 22) . It is generally associated with specific species in solution, by far the most common of which is chloride.…”

Effect of Repeated use on Topographical Features of ProTaper Next Endodontic Rotary File

“…Therefore, examining the surface of endodontic files would have an important impact on the identification of fracture initiation and file failure. 7 New endodontic instruments have been subjected to new strategies to improve flexibility, resistance to fracture, fatigability, and cross-sectional designs compared to conventional NiTi instruments. Manufacturers have also proposed different thermomechanical treatments.…”

Stress distribution for NiTi files of triangular based and rectangular based cross-sections using 3-dimensional finite element analysis

“…실제 응력분포에 영향을 주는 요소로는 cross-sectional inertia, 날의 깊이, 내부 코어의 넓이, 라디알 랜드, 그 리고 peripheral surface ground 등이 있다 11,26,27) . Schäfer 등 …”