The Exposure Height of Silicon Particle with Round Edges Effect on the Tribological Property of Al-Si Alloy Cylinder Liner

Abstract

In order to improve the wear resistance of Al-Si alloy cylinder liners, surface treatment is usually used. The Al-Si alloy cylinder liner samples were prepared by mechanical grinding and laser finishing. The mechanical grinding samples were carried out by the independent design and development of a grinding machine. The laser finishing samples were laser-heated by a CO2 continuous transverse-flow laser. Both of the two surface treatments could provide the surfaces of protruding silicon particles with round edges to improve the wear resistance. However, in the exposure height of silicon particles with round edges, the study was lacking. The exposure height of silicon particles is important to the tribological properties of the Al-Si alloy cylinder liner, and should be analyzed in detail. The wear tests were completed by a contraposition reciprocating wear test rig under lubrication. It was found that when the silicon particles were exposed on the surface of the Al-Si alloy cylinder liner sample by 1.2 μm, the mechanical grinding samples and laser finishing samples all exhibited minimum friction coefficients and weight losses. This paper confirms that a suitable exposure height of silicon particles would reduce the probability of adhesion wear and abrasive wear of Al-Si alloy cylinder liners and increase the lubrication. It presents an excellent tribological property. However, when the exposure height of silicon particles is too high, the silicon particle is easily prone to plastic deformation or even falls off during the friction process due to the high stress and larger plastic contact index.