The hydrothermal alkaline alteration of potassium feldspar: A nanometer-scale investigation of the orthoclase interface

Abstract

Potassium feldspars (KAlSi3O8) are ubiquitous minerals in the Earth's upper crust. This family of minerals has been the subject of numerous experimental and theoretical investigations concerning their dissolution kinetics and the mechanisms controlling chemical alteration at acid and neutral pH, and at temperatures ranging from ambient to hydrothermal conditions. On the other hand, considerably less research on the dissolution behavior of K-feldspars has been carried out at alkaline conditions, in particular at pH > 9 and elevated temperatures. Filling in this gap in knowledge is the major motivation for this study. More specifically, we wanted to document and understand how the K-feldspar interface structurally and chemically evolves during alteration in order to determine the mechanism of dissolution.In this study we examined interfaces of orthoclase samples that were altered in separate experiments in a Ca(OH)2-H2O solution (pH25°C 12.4) at 190 °C for 24 hours. We used a combination of focused ion beam (FIB) milling and advanced analytical transmission electron microscopy (TEM) techniques to investigate the structure and chemistry of the near surface region of post-reaction grains, with particular attention being given to the fluid-solid interface. Even though each grain diminishes in volume due to dissolution, high-resolution TEM imaging indicates that the feldspar structure itself remains completely intact and crystalline, as evidenced by lattice fringes that abruptly terminate at the grain edge.Nanometer-scale chemical composition measurements and mapping by TEM-EDXS (energy dispersive X-ray spectroscopy) and EFTEM (energy filtered TEM) show that the chemistry of the parent feldspar also remains unchanged at the interface. In particular, there is no evidence for the incursion of Ca from the fluid solvent into the structure, either by interdiffusion or by a replacement process. Taken together, the TEM observations point to a sharp chemical reaction front characterized by the congruent (i.e. stoichiometric) release of all elements from the feldspar structure.Nanometer-scale measurements by high resolution analytical TEM also reveal that a surface alteration layer (SAL) of amorphous material forms in situ at the expense of the feldspar structure. The interface demarcates a spatially coincident and nm-sharp chemical and structural discontinuity between the parent feldspar and the amorphous phase. The amorphous SAL has a variable thickness, from under 10 nm up to ~200 nm. This is likely one of the first observed occurrences of a significant surface amorphous layer on feldspar due to alteration in an alkaline solvent. The lack of a gap between the two phases points to an interfacial dissolution-reprecipitation process that continuously operates during hydrothermal alteration, and mostly likely right from the onset of contact with the fluid. After the initial formation of the amorphous layer, a 1-2 µm-thick porous amalgam of secondary crystalline phases comprised of calcite, tobermorite, and hydrogrossular, as wel...

Nanoscale Mg-Depleted Layers Slow Carbonation of Forsterite (Mg2SiO4) When Water Is Limited

“…Comparison of Q0 to Q3 and Q4 peak areas (Figure ) indicates 77 ± 2% of the initial forsterite remains unreacted, in good agreement with the XRD analysis (see above). The literature ,,− suggests the remaining silica might form a layer on the forsterite surface. If all hydroxylated Q3 species form on the external surface of an idealized pure silica layer facing the fluid film and all Q4 species are located between Q3 and Q0 (forsterite), then the Q3/Q4 peak area ratio of 0.24 predicts a maximum thickness of approximately five silicate units, which translates to ∼2 nm using a silicate tetrahedron diameter of 3.8 Å.…”

Preparation and Synergistic Anti-Tumor Effect of Iridium Oxide Nanocomposites under Microscope

“…In this context, the rapid development of nanotechnology makes nanomaterials show great potential in tumor diagnosis and treatment. The development of nanomedicine provides a new strategy for improving clinical efficacy and reducing side effects [ 4 ] as shown in Figure 1 .…”

“…e development of nanomedicine provides a new strategy for improving clinical e cacy and reducing side e ects [4] as shown in Figure 1.…”

Enhanced weathering potentials—the role of in situ CO2 and grain size distribution

“…The Mg/Si molar ratios are always well above the theoretical value of 2 (Figure 5E), with values >100 at the beginning and an average long-term average of 47.8. The mechanism responsible for this non-stoichiometry can (in theory) result from either preferential Mg release, or preferential Si retention, and can only be elucidated with nanometer-scale solid-state surface analyses (e.g., Hellmann et al, 2012Hellmann et al, , 2021Zandanel et al, 2022).…”

“…If it is assumed that the formation of the ASL is governed by a coupled interfacial dissolution-reprecipitation (CIDR) mechanism (Hellmann et al, 2003(Hellmann et al, , 2012(Hellmann et al, , 2021, and the ASL is porous, it should not impede dissolution of the silicates (Putnis and Putnis, 2007). However, if the ASL is non-porous and impermeable to fluid exchange between the dissolving silicate surface and the surrounding bulk fluid, the dissolution reaction may become kinetically hindered, or in a worst-case scenario, the reaction rate would evolve to such low values so as to be unmeasurable (Putnis and Putnis, 2007).…”