The Method to Determine Sites and Facilities for Wind-Diesel Power Plants Construction

Pilipets, Polina; Vatin, Nikolai; Murgul, Vera

doi:10.4028/www.scientific.net/amm.680.510

Cited by 3 publications

(1 citation statement)

References 19 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The capacity factor is defined by the results of extrapolation of the available historical data on experimental wind measurement meteorological stations and should be refined basing on the results of the annual wind data measurement [16]. Cost of 1 kW of wind energy plant installed capacity is determined basing on the average market ratings of wind turbines manufacturers and should be confirmed by the results of direct negotiations with suppliers and offers [17,18].…”

Section: Investigations Resultsmentioning

confidence: 99%

Energy Efficient Solutions of Power Supply in North Regions

Елистратов

Kudryasheva

Pilipets

2015

AMM

Self Cite

View full text Add to dashboard Cite

This article contains information about power economic estimation of power complexes creation based on renewable energy located in north regions with decentralized electric supply, where in the main electricity is produced by diesel power plants. Problems of using diesel power plants is measured; investigation of introducing wind-diesel power complexes is shown. Article contains information about power economic estimation, which allows to find out optimized solution to problem of choosing optimized energy and economic parameters of energy complexes.

show abstract

Section: Investigations Resultsmentioning

confidence: 99%

Energy Efficient Solutions of Power Supply in North Regions

Елистратов

Kudryasheva

Pilipets

2015

AMM

Self Cite

View full text Add to dashboard Cite

show abstract

Determination of Glazing Material’s Influence on the Energy Performance of Office Buildings Using Dynamic Simulation Techniques

Harmathy

2016

MATEC Web Conf.

View full text Add to dashboard Cite

Abstract. This investigation presents a detailed analysis in an effort of building energy performance improvement from the aspect of building envelope and glazing influence on the annual heating and cooling energy demand. This work is the continuance of our previous envelope optimization investigation and elaborates the influence of five different glazing types on the annual heating and cooling energy demand of the reference office building in compliance with energy efficiency regulations. Total annual energy demands were determined according to the building envelope's thermal performance and glazing characteristics. Findings from the dynamic simulations indicated the influence of glazing parameters (Uvalue, Solar heat gain coefficient) on the annual heating and cooling demand of the multi-zone building model. From the five simulated envelopes it was concluded that with adequate window application the annual heating demand could be reduced by 27% and the annual cooling demand by approximately 40%.

show abstract

Technical and economic viability of electric power plants on the basis of renewable energy resources regarding hierarchical structure

Balzannikov

2017

MATEC Web Conf.

View full text Add to dashboard Cite

Abstract. The article deals with power stations working on the basis of non-renewable energy resources and finite resources which will inevitably come to depletion in the future. These installations produce considerable negative impact on the environment, including air pollution. It is noted that considerable amounts of emissions of harmful substances accounts for the share of small thermal installations which aren't always considered in calculations of pollution. The author specifies that emission reduction of harmful substances should be achieved due to wider use of environmentally friendly renewable energy resources. It is recommended to use hierarchical structure with the priority of ecological and social conditions of the region for technical and economic viability of consumers' power supply systems and installations, based on renewable energy resources use. At the same time the author suggests considering federal, regional and object levels of viability. It is recommended to consider the main stages of lifecycle of an object for object level: designing, construction, operation, reconstruction of an object and its preservation. The author shows the example of calculation of power plant efficiency, based on renewable energy resources during its reconstruction, followed by power generation increase.

show abstract

The Method to Determine Sites and Facilities for Wind-Diesel Power Plants Construction

Cited by 3 publications

References 19 publications

Energy Efficient Solutions of Power Supply in North Regions

Energy Efficient Solutions of Power Supply in North Regions

Determination of Glazing Material’s Influence on the Energy Performance of Office Buildings Using Dynamic Simulation Techniques

Technical and economic viability of electric power plants on the basis of renewable energy resources regarding hierarchical structure

Contact Info

Product

Resources

About