The Optimal Composition of Diesel Particulate Filter Using Induction Heating

Kubota, Sachio

doi:10.1109/epepemc.2018.8521946

Cited by 3 publications

(1 citation statement)

References 8 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…In induction heating principle, the coil through which the alternating current will flow, circles around the piece to be heated, but doesn't touch it. While the needed heat for the temperature to rise is provided to the material from the outer surface in classical methods, needed heat is produced within the material itself with induction heating [4].…”

Section: Introductionmentioning

confidence: 99%

Power Factor Correction in Induction Heating System Using PFC Boost Converter

Çalik¹,

Yalcin²,

Şehirli³

2020

European Journal of Technic

View full text Add to dashboard Cite

Today, with the increased energy needs, carbon emission caused by energy production affects the environment negatively. This situation has made it necessary that electrical energy should be used efficiently. In order to achieve this, institutions such as IEEE and IEC have established some electrical energy standards to be complied with, by the consumers. In order to increase energy efficiency following these standards, current and voltage harmonics in the system must be eliminated or kept at the required limit. Otherwise, these harmonics will cause deterioration of receivers fed from the distribution network or decrease in operating performance. For this reason, power factor correction (PFC) processes are applied in power systems. Induction heating systems, which have found a wide area of use in recent years, require PFC process due to their structure consisting power electronics elements and inductive heating crucible. This study aims to eliminate the network harmonics and harmonics distortions and to bring the power factor (PF) closer to '1' by using AC-DC converter with PFC in induction heating system. Induction heating system designed in the study has three phases and has a full bridge parallel resonance inverter operating at a frequency of 20 kHz and power of 17 kW. The system uses full wave uncontrolled rectifier and boost type DC-DC converter. Voltage control is provided through the PID controller. Designed system is simulated in MATLAB. Current and voltage graphics measured from network and load were evaluated, PF and THD values were analyzed.

show abstract

Section: Introductionmentioning

confidence: 99%