The preparation of powder samples

Verdingh, V.

doi:10.1016/0029-554x(72)90627-1

Cited by 14 publications

(3 citation statements)

References 0 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Fabrication of Mo targets by different methods was reported by several investigators [1][2][3][4][5][6][7][8][9][10][11][12]. Kheswa et al [9] and Karasek [10] have described the possibilities of cold rolling in Mo target preparation.…”

Section: Methodsmentioning

confidence: 95%

Recent target development activities at Inter-University Accelerator Centre

Abhilash

Gehlot

Banerjee

et al. 2015

J Radioanal Nucl Chem

View full text Add to dashboard Cite

The target development laboratory at InterUniversity Accelerator Centre (IUAC) is one of the main facilities for the fabrication of nuclear physics targets in India. Vacuum evaporation and cold rolling technique are mainly used for the production of isotopically pure targets at IUAC. Targets of Gd, Pt, W, Mo, Ta, Ni, Ag and Sn have been developed in the form of self-supporting targets and with thin carbon backing. Recent progress in target development laboratory at IUAC will be discussed in the report.

show abstract

Section: Methodsmentioning

confidence: 95%

Recent target development activities at Inter-University Accelerator Centre

Abhilash

Gehlot

Banerjee

et al. 2015

J Radioanal Nucl Chem

View full text Add to dashboard Cite

show abstract

“…The specific activities of the spiked soil samples were determined by applying the procedure given by Verdingh (1972). The quoted uncertainties include measurement uncertainties of mass and dissolvent volume determination, and chemical purity of U 3 O 8 .…”

Section: Soil Standardsmentioning

confidence: 99%

Determination of the specific alpha activity of thick sources with a large area ZnS(Ag) scintillation detector

Djurašević

Vukanac

Kandić

et al. 2007

Journal of Environmental Radioactivity

View full text Add to dashboard Cite

“…In case thick targets are required with an areal density up to g•cm -2 , preferably a metallic disc is used. In case the isotope of interest is only available as a powder and the conversion into a metal is not possible, the powder is compacted into mechanically stable pellets [2].…”

Section: Introductionmentioning

confidence: 99%

Production of powder targets for neutron-induced cross section measurements

et al. 2023

View full text Add to dashboard Cite

Nuclear powder targets for neutron-induced cross section measurements were prepared by pressing. The choice of the production technique was related to the type of nuclear experiment and the quality of the powder. This paper describes the production process of unsintered compacts of 94Mo, 95Mo, 96Mo metal powders and 239PuO2 powder with a thickness as low as possible by uniaxial pressing of powders. Special attention goes to the difficulties encountered during the preparation process of 239PuO2 pellets. Investigation on the presence of impurities and so the quality of the PuO2 material was performed by scanning electron microscopy with energy dispersive X-ray spectroscopy, by inductively coupled plasma mass spectrometry, X-ray diffraction and by thermal analysis.

show abstract

The preparation of powder samples

Cited by 14 publications

References 0 publications

Recent target development activities at Inter-University Accelerator Centre

Recent target development activities at Inter-University Accelerator Centre

Determination of the specific alpha activity of thick sources with a large area ZnS(Ag) scintillation detector

Production of powder targets for neutron-induced cross section measurements

Contact Info

Product

Resources

About