The southern IOCG and hydrothermal nickel mineralization trend of the Carajás Mineral Province: Airborne geophysical and remote sensing evidences for structural controls and hydrothermal signature

Dutra, Luiz Fernandes; Louro, Vinicius Hector Abud; Monteiro, Lena Virgínia Soares

doi:10.1016/j.jappgeo.2023.105016

Cited by 6 publications

(2 citation statements)

References 44 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Airborne gamma-ray spectrum technology is a specialized remote sensing method that collects gamma rays emitted from surveyed areas using onboard detection equipment. This technique provides extensive geological, geophysical, and environmental insights [1][2][3][4] and is valuable for detecting underground resources like mineral deposits and water sources [5][6] , as well as for environmental monitoring [7][8] , disaster warning [9][10] . It surpasses traditional remote sensing methods with its greater penetration depth and sensitivity, reaching tens to hundreds of meters underground for a broader detection range and higher resolution.…”

Section: Introductionmentioning

confidence: 99%

See 1 more Smart Citation

Parallel Acceleration Algorithm for Wavelet Denoising of UAVAGS Data Based on CUDA

Xiong,

Wang,

Qiao

et al. 2024

Preprint

View full text Add to dashboard Cite

The computational efficiency is low when the vast volume of unmanned aerial vehicle airborne gamma-ray spectrum (UAVAGS) data is handled by wavelet denoising in CPU. So, a CUDA-based GPU parallel solution is recommended to resolve this issue in this paper. This proposed solution aims to significantly enhance the efficiency of parallel acceleration for wavelet denoising of UAVAGS data. In the preliminary stage, experiments were conducted with varying block sizes to investigate the influence of different block sizes on processing time. The objective was to identify the most suitable block size for efficiently processing UAVAGS data. Subsequently, a performance evaluation was conducted by comparing the acceleration ratios of GPU and CPU for different data volumes, as well as varying wavelet basis functions under the same data volume conditions. Finally, by intentionally introducing noise, calculations were performed to determine the optimal wavelet basis function concerning signal-to-noise ratio after denoising. The research findings indicate that the optimal two-dimensional block size falls within the range of 64×64 to 128×128. The majority of wavelet basis functions achieved acceleration ratios exceeding 100-fold in total processing time, with the coif5 wavelet basis function reaching an acceleration ratio of 185-fold. Comparative analysis of various denoising functions revealed that, under low signal-to-noise ratios, these functions exhibited insufficient denoising effects, while at high signal-to-noise ratios, there was a risk of excessive denoising. However, significant denoising effects were observed when employing hard thresholding with coif5, soft thresholding, and an improved thresholding method with db3.

show abstract

Section: Introductionmentioning

confidence: 99%

“…Fig 4. Changes in the acceleration ratio and total time acceleration ratio of the improved threshold denoising function with different data volumes (Unit: ms).…”

mentioning

confidence: 99%