Thermal and Optical Properties of CdS Nanoparticles in Thermotropic Liquid Crystal Monomers

Abstract

Two new mesogenic monomers, namely 3,3’-dimethoxy-4,4’-di(hydroxyhexoxy)-N-benzylidene-o-Tolidine (Ia) and 4,4’-di(6-hydroxyhexoxy)-N-benzylidene-o-Tolidine (IIa), were reacted with cadmium sulfide (CdS) via an in situ chemical precipitation method in ethanol to produce CdS nanocomposites. A series of different mass compositions of CdS with Ia and IIa ranging from 0.1:1.0 to 1.0:1.0 (w/w) were prepared and characterized using X-ray Diffraction (XRD), Raman spectroscopy, Fourier Transform Infrared Spectroscopy (FT-IR), Transmission Electron Microscopy (TEM), Polarizing Optical Microscopy (POM) and Differential Scanning Calorimetry (DSC), X-ray Photoelectron Spectroscopy (XPS) and Photoluminescence Spectroscopy (PL). XRD showed that the broad peaks are ascribed to the formation of cubic CdS nanoparticles in both Ia and IIa. The average particle size for both nanocomposites was less than 5 nm with a narrower size distribution when compared with pure CdS nanoparticles. The analyses from POM and DSC demonstrated that mass composition from 0.1:1.0 up to 0.5:1.0 of CdS:Ia nanocomposites showed their enantiotropic nematic phase. On the other hand, polarizing optical microscopy (POM) for IIa nanocomposites showed that the liquid crystal property vanished completely when the mass composition was at 0.2:1.0. PL emissions for CdS: Ia or IIa nanocomposites indicated deep trap defects occurred in these both samples. The PL results revealed that addition of CdS to Ia monomers suppressed the photoluminescence intensity of Ia. However, the introduction of CdS to IIa monomers increased the photoluminescence and was at a maximum when the mass composition was 0.3:1.0, then decreased in intensity as more CdS was added. The XPS results also showed that the stoichiometric ratios of S/Cd were close to 1.0:1.0 for both types of nanocomposites for a mass composition of 1.0:1.0 (CdS:matrix).

Electrooptic and Dielectric Studies in Cadmium Sulphide Nanorods/Ferroelectric Liquid Crystal Mixtures

“…Nanomaterials as a doping agent into liquid crystalline materials have attracted great deal of attention due to their unique structure and physical properties. Recently, nanomaterials have been doped into LCs and studied for improvement in electro-optic and optical properties such as enhanced photoluminescence, higher polarization, fast response time, low operating voltage, and improved conductivity [8][9][10][11][12][13][14][15][16][17]. For enhancing the physical properties, a proper selection of nanomaterials for liquid crystals depends upon various factors such as size, shape, preparation methods, surfactant concentration, and amount of doping materials [18,19].…”

Ethanol sensor development based on ternary-doped metal oxides (CdO/ZnO/Yb2O3) nanosheets for environmental safety

“…3b, is broad and asymmetric, indicating the presence of multicomponent oxygen species. 34 In Fig. 3d peak of the Yb 4d spectrum in Fig.…”

P‐Nitrophenol Degradation Using N‐Doped Reduced Graphene‐CdS Nanocomposites

“…This behavior could be explained by the disappearance of the luminescence centers, meaning reduction of the electron–hole recombination. In this case, the PL emission by CdS would result in a shift of PL to a higher wavelength . CdS with a direct energy band gap of about 2.5 eV due to formation of nanosize cadmium sulfide exhibits the electron affinity of χ CdS = 4.79 eV .…”