Thermomechanical Fatigue of Heat Resistant Austenitic Alloys

Calmunger, Mattias; Wärner, Hugo; Chai, Guocai; Segersäll, Mikael

doi:10.1016/j.prostr.2022.12.247

Cited by 2 publications

(1 citation statement)

References 9 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Other challenges that metallic materials face in biomass energy are abrasive wear [92], material degradation due to small dusty particles [93], and thermomechanical fatigue (high-temperature fatigue) [94][95][96].…”

Section: Biomass Renewable Energymentioning

confidence: 99%

Sustainable New Technology for the Improvement of Metallic Materials for Future Energy Applications

Jovičević-Klug,

Rohwerder

2023

Coatings

View full text Add to dashboard Cite

The need for a more sustainable and accessible source of energy is increasing as human society advances. The use of different metallic materials and their challenges in current and future energy sectors are the primary focus of the first part of this review. Cryogenic treatment (CT), one of the possible solutions for an environmentally friendly, sustainable, and cost-effective technology for tailoring the properties of these materials, is the focus of second part of the review. CT was found to have great potential for the improvement of the properties of metallic materials and the extension of their service life. The focus of the review is on selected surface properties and corrosion resistance, which are under-researched and have great potential for future research and application of CT in the energy sector. Most research reports that CT improves corrosion resistance by up to 90%. This is based on the unique oxide formation that can provide corrosion protection and extend the life of metallic materials by up to three times. However, more research should be conducted on the surface resistance and corrosion resistance of metallic materials in future studies to provide standards for the application of CT in the energy sector.

show abstract

Section: Biomass Renewable Energymentioning

confidence: 99%

Sustainable New Technology for the Improvement of Metallic Materials for Future Energy Applications

Jovičević-Klug,

Rohwerder

2023

Coatings

View full text Add to dashboard Cite

show abstract

Thermomechanical Fatigue Behavior of a Cast Austenitic Stainless Steel

Liu,

Hess,

Wang

et al. 2024

SAE Technical Paper Series

View full text Add to dashboard Cite

<div class="section abstract"><div class="htmlview paragraph">Cast austenitic stainless steels, such as 1.4837Nb, are widely used for turbo housing and exhaust manifolds which are subjected to elevated temperatures. Due to assembly constraints, geometry limitation, and particularly high temperatures, thermomechanical fatigue (TMF) issue is commonly seen in the service of those components. Therefore, it is critical to understand the TMF behavior of the cast steels. In the present study, a series of fatigue tests including isothermal low cycle fatigue tests at elevated temperatures up to 1100°C, in-phase and out-of-phase TMF tests in the temperature ranges 100-800°C and 100-1000°C have been conducted. Both creep and oxidation are active in these conditions, and their contributions to the damage of the steel are discussed.</div></div>

show abstract

Thermomechanical Fatigue of Heat Resistant Austenitic Alloys

Cited by 2 publications

References 9 publications

Sustainable New Technology for the Improvement of Metallic Materials for Future Energy Applications

Sustainable New Technology for the Improvement of Metallic Materials for Future Energy Applications

Thermomechanical Fatigue Behavior of a Cast Austenitic Stainless Steel

Contact Info

Product

Resources

About