Three-Dimensional Analysis of Load Transfer Mechanism for Deep Cement Mixing Piled Embankment under Static and Cyclic Load

Abstract

Piles have been widely used to improve the bearing capacity of the soft foundation. The existing research obtains significant findings on the load transfer mechanism for rigid piled embankments. However, limited studies have been focused on the deep cement mixing (DCM) piled embankment. To grasp the load transfer characteristics of DCM piled embankments, a three-dimensional numerical simulation was conducted in this study, which was validated by the measurements from the field case. It was found that the effect of soil arching was reduced compared with the rigid piled embankment. This induced approximately 61.5% larger vertical stress transferred to the subsoil surface and approximately 83–150% larger settlement of the embankment in DCM piled foundation system. To further understand the working mechanism of this system, the factors which influence the load transfer mechanism were investigated. It is found that the area replacement ratio is the most influential factor affecting the settlement at the top of the embankment, whereas the elastic modulus of the DCM pile influences most the vertical stress and the earth pressure coefficient. The cyclic load with vehicle speeds of 90 km/h will lead to approximately 34% growth of embankment settlement and about 11% reduction in the maximum earth pressure coefficient. Based on the numerical simulation results, the analytical equation of the normalized vertical stress acting on the subsoil surface for the DCM piled foundation was proposed and validated by two field cases, with the difference in the range of 13.8~16.7%.

Embankments Reinforced by Vertical Inclusions on Soft Soil: Numerical Study of Stress Redistribution

“…Jamsawang et al [27] conducted an FEM analysis based on field measurements to investigate the performance of DCM columns including load distribution. Then, Cui et al [28] further developed that study to show the influence of the elastic modulus of DCM columns on the stress distribution. However, the arching effect has not yet been evaluated in these studies, as well as the effects of using geosynthetic reinforcement.…”